– 56 –Status Displays Inside the Viewfinder ScreenChanging the Display ModeThe display mode setting appears on the VF DISPLAY page of the setting menu.1 Perform the operations in steps 1 to 3 of “Selecting Display Items” (page 54) to display theVF DISPLAY page of the setting menu on the viewfinder screen and align the cursor withthe DISP MODE item.2 Press the UP or DOWN button to select the desired display mode.3 When menu operations have been completed, set the MENU SET/OFF switch to OFF.Setting the Marker DisplaysDisplay ON/OFF switching for the center and safety zone markers and selection of 80% or 90%of the screen area as the safety marker range are performed at the MARKER page of the settingmenu.1 Set the MENU SET/OFF switch to SET.The page on which the previous setting menu operations were completed appears on theviewfinder screen. (When the menu is used for the first time, the first page appears.)2 Press the PAGE button until the MARKER page shown below appears.(This operation can also be performed using the PAGEoUP/DOWN function.)3 Press the SHIFT/ITEM button to move the cursor to the position of the desired item.4 The setting switches to ON or OFF each time the UP (or DOWN) button is pressed.5 When menu operations have been completed, set the MENU SET/OFF switch to OFF.The setting menu disappears from the viewfinder screen and the displays indicating theunit’s current status appear at the top and bottom of the viewfinder screen.- M ARKER -¢ CENTER M ARK : O NSAFETY Z O NE : 1
