Panasonic AJ-HD1400E Operating Instructions Manual

Also see for AJ-HD1400E: Mechanical Parts List

52Setup menus (continued)AUDIO (continued)*1 Displayed menus may vary depending on the settings inmenu No. 25 SYSTEM FREQ. For details, refer to“Menus which are displayed” (page 32).“_____” indicates the factory setting.No./Item Description of setting750ANA CH1/2SELFor selecting the channel for the signal output to theanalog audio output terminal CH1/CH2.0000 CH1/20001 CH3/40002 CH5/60003 CH7/8759*1DV PB ATTFor selecting the audio output level during DV formatplayback.0000 OFF :The audio output level is not attenuated.0001 ON :The audio output level is attenuated.760*1REC PTMUTEFor selecting whether to mute the sound at the joinsin the recording during DV or DVCAM formatplayback.0000 OFF :The sound is not muted.0001 ON :The sound is muted.762AUD RATECONFor setting whether the tape is to be played backwithout passing the signals through the rate converter(without activating the digital filter) in the digital audiooutput unit.0000 OFF :The tape is played back without passing the signalsthrough the rate converter.0001 ON :The signals are passed through the rate converter,and the tape is played back.ON/OFF control is exercised for channels 1 through 8at the same time. Separate settings cannot beperformed on a channel by channel basis.765CUE OUTSELFor setting whether to output the analog CUE signalto CH1/2 for the analog audio output.0000 OFF :The analog CUE signal is not output.The PCM audio signal is output when the speedrange is less than j1.0k to +1.0k; while the noaudio signal is output at any other speed.0001 ON :The analog CUE signal is output.The PCM audio signal is output when the speedrange is less than j1.0k to +1.0k; while theanalog CUE signal is output at any other speed.781*1IN IMP SELFor setting the analog audio input impedance.0000 600 :600h0001 HIGH :High impedanceRegardless of this setting, the impedance is set to3kh. when “–60 dB” is selected as the menu itemNo.701 to 702 settings.No./Item Description of setting782EMBD CHSELSet the channels to multiplex SD-SDI output.0000 CH1-4 :0001 CH5-8 :When tape other than DVCPRO HD (LP) is played,CH1 to CH4 is always multiplexed.783AUDIO CHSELFor selecting channels that are adjusted with theaudio volume control on the front panel and displayedon the audio level meter.0000 CH1-4 :Select CH1–CH4.0001 CH5-8 :Select CH5–CH8.784MONI SELINHSelect enabled/disabled for MONITOR SELECTbutton operation on the front panel.0000 OFF :Operation is enabled.0001 ON :Operation is disabled.0002 ON1 :Operation is disabled in the FULL display modewhile the operation is enabled only in the FINEdisplay mode.