Introduction: Jog and Shuttle Operations Using the Search Dial 35IntroductionJog and Shuttle Operations Using the Search DialThe search dial is used to search and check video.Each press of the dial alternates it between SHTL mode andJOG mode.When the power is turned on, the search dial will not operateunless it is first returned to the STILL position.1 Press the search dial so that it remains pressed in.The jog mode is now engaged.2 Turn the search dial.The dial’s click stops are released and playback isperformed at the speed the dial (–1 to +1×) is turned.When the dial stops turning, the video becomes a stillpicture.3 To go to another mode from the jog mode, press thebutton of the desired mode.◆ NOTE:• The direct search mode that allows you to go directly to theshuttle mode or jog mode by turning the search dial is a factorydefault.• You can select [KEY] in setup menu No. 100 (SEARCH ENA) sothat the unit will not engage the search mode unless you pressthe STILL/PAUSE button.1 Press the search dial to release it.This engages the shuttle mode.When the power has just been turned on, turn the searchdial to its center position.2 Press the STILL/PAUSE button.3 Turn the search dial.The playback picture speed changes from 0 to ±32×depending on dial position.Use setup menu No. 101 (SHTL MAX) to set maximumspeed to ±8, ±16, ±32, ±60 or ±100×. The dial has a click-stop at the center for viewing still pictures.4 To go to another mode from the shuttle mode, pressthe STOP button or other button.◆ NOTE:• The playback audio is audible at speeds in the range –10 to+10× from the audio monitor output.• The playback audio in the search mode contains noise.• Playing back a clip that spans a multiple of P2 cards at speedsfaster than ±1× may break up the sound in the transition toanother card; this is normal and not indicative of a malfunction.• Playing back a clip at speeds faster than –10× may break up thesound; this is normal and not indicative of a malfunction.Jog ModeShuttle Mode (SHTL Mode)
