54 Clip Management: Attaching Metadata to Clips■ Incrementing the COUNT value of the USERCLIP NAME for clips exceeding 4 GBIn the following case, one shot is recorded as multiple clipsand the COUNT value is automatically incremented andrecorded for each shot.• When an 8 GB or larger P2 card is used in this unit and eachcontinuous recording exceeds a preset time.➝For details, refer to “Dividing clips over 4 GB in length”(page 34)• When one recording spans multiple cards.A P2 device will indicate the thumbnail and COUNT value ofclip 1 when thumbnails and property of the clip are displayed.Use the following procedure to load metadata from an SDmemory card.1 Insert the SD memory card storing the metadataupload file.2 Open the thumbnail screen.3 Press the MENU button.4 Use the cursor buttons to select [META DATA] –[LOAD] and press the SET button.The filename of the metadata upload file on the SDmemory card appears.◆ NOTE:• When the file name is displayed, use the right cursor button toshow the metadata name. Use the left cursor button to show thefile name.5 Use the cursor buttons to select the file to load andpress the SET button.6 Select [YES] and press the SET button.The file is now loaded.7 Press the MENU button to end processing.Use the following steps to check metadata loaded from an SDmemory card.1 Press the THUMBNAIL button.The thumbnail screen appears on the LCD monitor.2 Press the thumbnail menu button and select [METADATA] – [PROPERTY] from the Thumbnail menu.The screen shown below appears.Loading Set Metadata ValuesExample of a recording on one P2 card (DVCPRO HD):Example of recording a clip on two P2 cards:REC start(start of recording)Stop(recording stop)REC start(start of recording) Stop(recording stop)Recording duration = 6 minutesClip 1COUNT value = AClip 2COUNT value = A + 1Approx. 5 min. Approx. 1 min.Clip 1COUNT value = AClip 2COUNT value = A + 11st card 2nd cardChecking and Revising Loaded Metadata