82 Using Play List: Overwrite Editing of Play Lists1 Press the PLAY button in the play list screen todisplay video.2 Press the IN (OUT) + GOTO buttons or operationbuttons and press the IN (OUT) + ENTRY buttonswhere the revision will be made to reregister.You can perform fine adjustment (trimming) by hold downthe IN (OUT) button and pressing the TRIM (+/–) button.1 Hold down the SHIFT button in the play list screenand press the IN (OUT) button.2 The screen for revising IN/OUT points appears in PIN (P OUT) ➝ R IN (R OUT) ➝ OFF order.3 Press the TRIM+/– button to trim.◆ NOTE:• The RESET button clears registered points.• Holding down the button enables fast-forwarding.4 Press the ENTRY button to finalize the change.Or press the SET button to finalize.Use the following steps to preview overwritten area (in orange)to check audio and video.1 Hold down the SHIFT button and press the PLAYbuttonPlayback starts 3 seconds prior to the overwritten areaand 1 second after the area.◆ NOTE:• Press the STOP button to stop previewing.• Overwrite edited events in unfinalized status (all events if morethan one) are played back regardless of pointer location.• The sound can be adjusted only during a preview.2 Use the playback volume to adjust playback levelduring preview.• The playback level is fixed at the level set duringpreview.• Review and play list playback plays back events at theimported sound volume.◆ NOTE:• When there are multiple events, all events are played back atthe same sound volume.• The same sound volume is used in an event and cannot bechanged.Use the steps below to finalize overwrite edited events inunfinalized status and return to normal event operation.1 When there are any unfinalized events, press theREC button.2 This finalizes the event and changes the orange ofthe unfinalized event to white.◆ NOTE:• When an event is not to be registered, clear the IN or OUT pointor use CANCEL (hold down the SHIFT button and press the EXITbutton) to clear all IN and OUT points.• Exiting the play list by pressing the PLAYLIST button clears allunfinalized events and all IN and OUT points.• Use the following steps to change channel settings afterfinalizing an event.1. Select an event or multiple events to edit.2. Choose [SETTING] – [AUDIO CH] from the menu to changethe channel setting.3. Choose [OPERATION] – [EDIT AUDIO CH] from the menu.4. Select YES.The recalling method can also be used.➝Refer to “Recalling Events” (page 83).Revising R IN/R OUT while Viewing VideoRevising in the Play List ScreenPreviewing and Adjusting Sound VolumeFinalizing Overwrite Editing