Panasonic AJ-SD930BE Operating Instructions Manual

Also see for AJSD955B - DVCPRO50 STUDIO DECK: Service manual Brochure & specs

23 (E)CONTENTSAutomatic editing (deck-to-deck) SD955B1 Press the IN (or OUT) button to check the editpoint. The value of the registered edit pointappears on the display panel.2 While holding down the IN (or OUT) button, pressthe PREROLL button and check the picture at theedit point.The tape is cued up to the edit IN (or OUT) point,and a still picture of the point appears.O If STOP has been selected as the setup menuNo. 315 (AFTER CUE-UP) setting or if theMODE switch has been set to EE, the VTR isset to the E-E mode.3 By holding down the IN and OUT buttons at thesame time, check the editing duration.The duration appears on the display panel.How to calculate the durationO When two edit points have been set:Duration between the two pointsO When only one edit point has been set:Duration between the data which has beenset and the current addressO When no edit points have been set:Duration of the previously edited section4 After the edit points have been registered, pressthe PREVIEW button.Regular preview is now conducted.O If the edit IN point has not been registered, theposition where the PREVIEW button waspressed is registered as the edit IN point.O To stop the preview at any time, press theSTOP button.O When the PREVIEW button is pressed againafter the IN point during the course of a preview,the preview will start again from the beginning.O When the edit OUT point is reached, the tapestops automatically.Checking and previewing edit pointsONOFFPOWERDVDVCPRODVCPRO 50METERLRFULL/FINEMONITOR SELECTHEADPHONESMONITORMIXA VOLSELECTINPUT SELECTPREVIEW/PREVIEWAUTO EDITPREROLLVIDEOREC LEVELCH1PB LEVELAUDIOCH2 CH3 CH4 TCPRESETMENU SET DIAGSUPER REC INHINT TCGMODECONTROLONOFFUNITYVARCOUNTERRESETA INTRIMSETOUTINA OUTCH1 CH4CH2INSERTCH3ASSEM VIDEO CUE TC STAND BYEDITREW STOPPLAY RECPLAYER RECORDERFFJOG SHTL SLOWTAPEEEONREGENPRESETEXITOFFREMOTELOCAL4 1/32