18Filter MenuThe FILTER menu is activated by pushing the FILTER button on the UFC front panel. This menu allows the user toselect the filtering and enhancement responses for the system. The user may select different responses orenhancement settings depending upon the type of conversion being done (up or down) or the nature of the sourcematerial (soft material may need more enhancement, noisy material may need less).F I L T E RH R E S P V R E S P H E N H V E N H 2 - D E N HF1 F2 F3 F4 F5 EXITF1 – Activates knob to select the horizontal filter response (Wide, Standard, or Narrow).F2 – Activates knob to select the vertical filter response (Wide, Standard, or Narrow).F3 – Activates knob to select the amount of horizontal enhancement (0 to +6dB in 0.5dB steps).F4 – Activates knob to select the amount of vertical enhancement (0 to +6dB in 0.5dB steps).F5 – Activates knob to select the amount of two-dimensional enhancement (0 to +7dB in 1dB steps).Note: H ENH and V ENH operate on the input format during the band-limiting process while 2-D ENH operateson the output format. H ENH and V ENH have upper mid-band peaks while 2-D ENH has its peak at theupper band edge.Timing MenuThe TIMING menu is activated by pushing the TIMING button on the UFC front panel. The SYSTEM menu allowsthe user to select the sync reference for the system, as well as the type of sync used for the genlock output (bi-levelor tri-level). Timing of the output video with respect to sync may also be adjusted by line (line advance) or bysample (horizontal position). If the horizontal position exceeds the total number of samples per output line; lineadvance will automatically be increased by one, and the horizontal position will be reset to zero.The FILM MODE menu allows for selection of a 3:2 reference, if applicable and allows for offsetting the film frameposition that is referenced. When time code is used as a reference, the hour that is used as the synchronization pointmay also be set.SYSTEMT I M I N G > > S Y S T E MR E F I N G L T Y P E L I N A D V S Y S HF1 F2 F3 F4 F5 EXITF1 – Activates knob to select the sync reference (Input, External Bi-Level, External Tri-Level, or Black Burst).F2 – Activates knob to select the genlock output sync type (Bi-Level or Tri-Level).F3 – Activates knob to select the line advance value (0-7H).F4 – Activates knob to select the horizontal position value (0-1H).Note: If an external sync source is selected, the video input must be vertically locked to the same source.