73Chapter 2: Operations in DV modeUsing the CounterCounter displayYou can display a counter that indicates how muchtime has elapsed during shooting or playback.1 Press the COUNTER button.Each time you press the button, the displaychanges as follows. (Page 9)0 : 00. 00 (CAMERA mode only)Counter valueCLIP 0 : 00 . 00 (CAMERA mode only)Displayed when CLIP is selected in theREC COUNTER item on the settings menuSW&DISP SETUP screen.Values are automatically reset whenrecording is started, and counter values aredisplayed for each individual clip.TC 12 : 34 : 56 . 01Time code value (When set to 4P mode,display time code frame digits in 30 frames.)UB 12 34 56 78User informationNo displayData is not displayed.Resetting the counterPress the RESET button while the counter isdisplayed.1394 TC preset modeYou can synchronize initial TC values whenshooting with multiple cameras (the followingdescribes the synchronization source as MASTERand the synchronized end as the SLAVE).1 Connect 2 devices with the IEEE1394 cableand set the power to ON.2 Set the MASTER to CAMERA mode, andthen set it so that video signals are outputfrom the DV terminal.Match the recording formats of the connected cameras, and set the TCG item(Page 10) in the setting menu RECORDSETUP to FREE RUN.The below operation are performed entirely bythe SLAVE.3 Press and hold the MODE button to switchto DV IN mode.4 Select OFF for the 1394 TC REGEN item(Page 102) in the RECORD SETUP screen,and then press the ENTER button.5 Select ON for the DV IN PRESET item (Page103) in the RECORD SETUP screen, andthen press the ENTER button.“DVTC” is displayed on the screen.6 Press the RESET/TC SET button.“TC SET OK” is displayed on the screen.The TCG value is reset to match the TCGvalue input from the DV terminal.7 Press and hold the MODE button to switchto CAMERA mode.••••
