|
Operations on the AW-RP120 Remote Camera ControllerFor operating the camera menus.CAMERA OSD:When this is pressed for 2seconds, the selected cameramenu is displayed, overlappingthe camera output image. Whenit is pressed for 2 seconds whilea camera menu is displayed, themenu is exited.F1: Turn to move the cursor up anddown in the camera menu or tochange setting values. Press tomove to the next level of a menuitem or to change a setting valueat the lowest level.Selects a camera to be operated. Camera menu operation1. Press the appropriate SELECT> button (<1> to <10>) to select the unit you wantto operate.2. Press and hold the button on the AW-RP120 for about 2 seconds.The AW-HE130 camera menu appears on the monitor.3. Turn the dial to select an AW-HE130 camera menuitem or to change a setting value.Turn the dial to move the cursor up and down or to changesetting values.Press the dial to move to the next level of a menu item or tochange a setting value at the lowest level.4. To exit the camera menu, press and hold the OSD> button for about 2 seconds. Switching between day and night mode1. Press the The button lights.2. Press the FUNCTION menu <23> button.The button lights, and the [OPTION] menu appears on the LCD panel.3. Turn the dial to select [FUNCTION], then press the dial.4. Turn the dial to select [OPTION].[Off] or [On] appears on the bottom right (F2 area) of the LCD panel.5. Turn the dial to select [Off] or [On], then press the dial.Off: Day modeOn: Night mode Color temperature setting (COLOR TEMP)1. Press the button and the button of simultaneously.The , , buttons of BAL> light, and colortemperature setting mode is enabled.The color temperature setting value appears on the LCD screenduring this time.2. Turn the dial to change the color temperature.Press the , , and buttons of BAL> to returnto the mode of the selected button.The mode will switch from the color temperature mode to the originalmode after a specific amount of time passes. To configure the colortemperature setting again, press the button and the button of BAL> simultaneously. Preset speed table setting (PRESET SPEED)1. Press the The button lights.2. Press the FUNCTION menu <23> button.The button lights, and the [OPTION] menu appears on the LCD panel.3. Turn the dial to select [PRESET SPEED], then pressthe dial.[Slow] or [Fast] appears on the bottom right (F2 area) of the LCDpanel.4. Turn the dial to select [Slow] or [Fast], then pressthe dial.41Basic setup operations (continued)
PreviousNext |