Operating InstructionsInstalling PTZ CntrlThe PTZ Cntrl app for iPad is provided by Panasonic Corporation. Itfacilitates panning and tilting of the HD integrated camera and smoothoperation of the lens by displaying the video of the unit and the videoof the HD integrated camera mounted to the unit and then touching theiPad screen. PTZ Cntrl compatible devices and operatingsystemsThe following iPads are supported.Supported devices: iPadSupported operating systems: iOS 8.1• Correct operation may not be possible depending on the iPad you use.For information on PTZ Cntrl, visit the following support site.http://pro-av.panasonic.net/1. Connect the iPad to the network.• The iPad needs to be connected to the Internet.2. Tap [App Store].3. Enter "Panasonic PTZ Cntrl" in the search field.4. Tap [PTZ Cntrl] and install the software.• An icon is added to the iPad menu.Connecting with the iPadConfigure the network settings of the unit and the HD integrated cameramounted to the unit*1 , and then set the IP address for each of them. Forthe IP address settings, refer to “Network settings” (→ page 30).*1 Connection cannot be performed when the HD integrated camera isin standby mode. Make sure the power is on.1. Start [PTZ Cntrl].2. Tap from the [PTZ Cntrl] screen to open the settingscreen.3. Tap [Camera Setting].• The [Camera Group] screen opens.4. Tap [Add Group] and then tap [Add Camera] of the[Camera Group] items.5. Tap the model name of the connected HD integratedcamera, and configure the IP addresses for [PTZ Camera]and [Sub Camera] (this unit).6. Tap [Close] to return to the setting screen.• Tap the (camera selection) button, and select the [CameraGroup] and [Camera]. Be sure to click [Connect] after selection.The video from the HD integrated camera is displayed in the upperarea, and the video from the unit is displayed in the lower area.• If the video does not appear, connection and communication withthe camera has not been established. Check the LAN cables, Wi-Fisettings, IP address settings, etc.For the detailed setting procedure, refer to the Help screen of PTZ Cntrl.Configuring the initial settings of PTZ CntrlThe shooting angle of view of the unit and the operation position of theHD integrated camera need to be adjusted. The difference betweenthe positional relationship in the video of the unit and the pan andtilt operation position of the HD integrated camera is minimized byperforming this correction operation.1. Tap from the [PTZ Cntrl] screen to open the settings.2. Tap [General] in the lower part of the setting screen.• The screen switches to calibration mode.3. Tap the upper area of the screen or use the [///]keys to match [+] marker image position of the upperarea of the screen to the area displayed at the center [+]marker in the lower area of the screen.Controlling the cameras with the PTZ Cntrl app31
