Panasonic BL-WV10 Operating Instructions Manual

Also see for BL-WV10: Brochure & specs Getting started

Contents

Panasonic BL-WV10 Operating Instructions Manual Manual pdf 32 page image

2 Setup32Note• If a user name and password has already been established for a camera, QuickSetup will be unable to replace that data with the user name and password forthe BL-WV10, and the camera will be registered as a remote camera. Toregister the camera as a local camera, reset the camera by pressing itsFACTORY DEFAULT RESET button before connecting it.• Quick Setup can take place within 20 minutes after the camera is turned on. Ifthe camera is not recognized, or if [Restarting camera] is displayed at thebottom of the screen for more than 2 minutes without camera registrationbeginning, reset the camera by pressing its FACTORY DEFAULT RESETbutton and reconnect the camera.• If a camera needs to be restarted during Quick Setup, camera configurationand restart will take about 2 minutes.• During Quick Setup, the wireless indicator will light in green.• Once registration is complete, the alarm will sound and the wireless indicatorwill flash green.2.5.4 Viewing Camera Images (When Not Using a Router)After you have registered cameras to the BL-WV10 using Quick Setup, confirm thatimages from the camera can be viewed using the BL-WV10.1. Connect all cameras that were registered using Quick Setup.• To use a wireless camera with the BL-WV10, turn the camera off,disconnect the Ethernet cable, set the camera's wired/wireless switch (if ithas one) to WIRELESS, then turn the camera on again.2. Turn on the BL-WV10 by connecting the DC cord to the unit.• The startup screen appears on the TV screen.3. Confirm that the camera image is displayed.• If multiple cameras are registered, press 0 to display the camera list, thenuse the up and down navigator keys to view images from each registeredcamera.Note• If the BL-WV10 does not receive date and time information from any of theconnected cameras, the [Date and Time] screen will appear. Select the currentdate and time using the navigator keys on the remote control, and pressENTER when finished.• If a camera image does not appear, check the connection and then restart thecamera. If the image still fails to appear, reset the camera to its default values,and re-register it using Quick Setup.• The date and time is displayed in the upper-right corner of the screen. If thedate and time setting is not correct, set the correct date and time (see page 80).