Panasonic CF-18 Series Reference Manual

Also see for Toughbook CF-18 Series: Precautions for Installing Precautions for Installing Operating instructions Supplementary instructions Supplementary instructions

108Dealing with Problems (Advanced)When resuming from the standby orhibernation mode, [Enter Password]does not appear even if a passwordhas been set in the Setup Utilityz Even when a password has been set in the Setup Utility, [Enter Password] doesnot appear when the computer resumes from the standby or hibernation mode.If you want to use the security function when using the standby or hibernationmode, use the Windows password as follows:A Select the account to change in [start] - [Control Panel] - [UserAccounts] and set the password.B Add the check mark for [Prompt for password when computerresumes from standby] in [Control Panel] - [Performance andMaintenance] - [Power Options] - [Advanced].When the administrator password isforgottenz If you have created a password reset disk (⇒ Operating Instructions "First-timeOperation"), a message is displayed when you fail to correctly enter thepassword. Follow the message's instructions and set the password again byusing the password reset disk.If you have not created a password reset disk, after reinstalling, setup Windowsand then set the password again.When "Remove disks or other media.Press any key to restart" (or a similarmessage) is displayedz This means a floppy disk that dose not contain system startup information hasbeen left in the floppy disk drive. Remove the floppy disk, and press any key.z This message may appear when certain USB devices are connected. Removethe USB device, or set [Legacy USB Support] in [Advanced] menu of the SetupUtility to [Disable].z If the message still appears even after trying the above measures, this may bean indication that some type of hard disk failure has occurred. ContactPanasonic Technical Support.[Executing Battery Recalibration]screen is displayedz This screen appears because the Battery Recalibration was canceled beforeWindows was shut down last. To start up Windows, turn off the computer bysliding the power switch, and then turn it back on again. Starting Up