Panasonic CS-VE9NKE Service Manual

Also see for CS-VE12NKE: Operating instructions Service manual

Contents

Panasonic CS-VE9NKE Service Manual Manual pdf 43 page image

4312.10 nanoe-G Operation This operation provides clean air by producing great amount of negative ions and distribute through thedischarge airflow to capture or deactivate molds, bacteria or viruses. nanoe-G ON/OFF conditionPriority Item Output“No NANOE-G” is selected during model selection.During Demo modeTwo-way communications on remote controlNANOE-G connector open1NANOE-G error (circuit error & abnormal discharge detection)OFFInspection mode NANOE-G ON command ON2 Inspection mode NANOE-G OFF command OFFNo “NANOE-G” setting on the remote controlOperation status: OFFDuring NANOE-G restart prohibiting time(Prohibiting time is set in the case of abnormal discharge and room temperature of 40°Cand above. Details will be provided later.)3During FM OFF; or FM rotation speed is less than 490 rpmOFFLess than 60 minutes have elapsedsince the start of Powerfulindividual fan operation.ONOrdinary vertical louver selected; or Airflowdirection is not set to ceiling airflow or DOWN Other than above4Twin louver is selected; or airflow direction is ceiling airflow or DOWN ON/OFFintermittent outputas mentionedbelow ON/OFF intermittent output nanoe-G operation pause conditiono When indoor fan stop (during deice, odor cut control, thermostat off, etc.). nanoe-G operation resume afterindoor fan restarts.o When indoor intake temperature ≥ 40°C. nanoe-G operation resume after indoor intake temperature ≤ 40°Ccontinuously for 30 minutes. Indoor fan controlo During any operation mode combines with nanoe-G operation, fan speed follows respective operation mode.However, nanoe-G system enabled when fan speed ≥ 490 rpm to ensure proper negative ion distribution,nanoe-G system disabled when fan speed < 490 rpm. Airflow direction controlo During any operation mode combines with nanoe-G operation, airflow direction follows respective operationmode.o During nanoe-G individual operation, only Auto Air Swing is allowed. Even if Air Swing button is pressed, nosignal is sent to the unit and no change on remote control display. Timer controlo When ON Timer activates when unit stops, previous operation resumes and restored last saved nanoe-Goperation status.o When ON Timer activates during any operation, no change on current operation.o When OFF Timer activates during any operation, all operation stops and the latest nanoe-G operation statusis saved. Indicatoro When nanoe-G starts, nanoe-G indicator ON.