Others110VQT0W88• You cannot attach the MC protector andthe PL filter at the same time.• If the MC protector/PL filter are tightenedtoo much, you may not be able to removethem. Do not tighten them too much.• When taking pictures with the flash usingthe MC protector or PL filter, vignettingeffect may occur.• If the MC protector/PL filter are dropped,they may be destroyed. Be careful not todrop them when attaching them to thecamera.• You can attach the lens cap or the lenshood when the MC Protector and the PLFilter are attached.• Read the operating instructions of the MCprotector or the PL filter for details.• MCu“Multi-coated”PLu“Polarizing lens filter”Using the RemoteShutterIf you use the remote shutter (DMW-RSL1;optional), you can avoid jitter (camerashake) when using a tripod and you cankeep the shutter pressed fully when takingpictures with [B] (Bulb) or burst mode. Theremote shutter works similar to the shutterbutton on the camera.1 Firmly connect the remote shutterto the [V OUT/REMOTE] socket onthe camera as far as it will go.2 Take a picture.1: Press the button lightly to presshalfway.2: Press the button fully to take thepicture. (Press it as far as it will go.)∫ About [LOCK] on the remote shutter• You can keep the shutter button pressedfully. This is effective when taking pictureswith [B] (Bulb) (P41) or in burst mode(P67).• While pressing the shutter button fully,slide it to the [LOCK] side.• Slide it to the other side to cancel [LOCK].• Do not use any other remote shuttersexcept DMW-RSL1 (optional).• You cannot operate the camera with theremote shutter in the following cases.– When the power save mode is cancelled– When you determine the part to betrimmed– When you determine the aspect ratioconversionV OUT /REMOTEUSB
