Panasonic DMC LZ1 - Lumix Digital Camera Operating Instructions Manual

Contents

44VQT1L86Advanced-ShootingAvailable flash settings by recording modeThe available flash settings depend on therecording mode.( : Available, — : Not available, : Initialsetting)* 2*2 When AUTO is selected, depending onthe type of subject or brightness, fl ashis set i AUTO [ ], i AUTO/Red-eyereduction [ ], or i Slow sync./Red-eye reduction [ ].The fl ash setting may change when you■•change the recording mode. Change thefl ash setting again if necessary.The fl ash setting is memorized even ifthe camera is turned off. However, thefl ash setting is reset to the initial settingwhen the advanced scene mode orscene mode is changed.The available flash range to take picturesISO sensitivity Available fl ash rangeAUTO 50 cm (1.64 feet) to6.8 m (22.31 feet) (Wide)1.0 m (3.28 feet) to3.8 m (12.47 feet) (Tele)ISO100 50 cm (1.64 feet) to2.1 m (6.88 feet) (Wide)1.0 m (3.28 feet) to1.2 m (3.94 feet) (Tele)ISO200 50 cm (1.64 feet) to3.0 m (9.84 feet) (Wide)1.0 m (3.28 feet) to1.7 m (5.58 feet) (Tele)ISO400 60 cm (1.97 feet) to4.3 m (14.11 feet) (Wide)1.0 m (3.28 feet) to2.4 m (7.88 feet) (Tele)ISO800 80 cm (2.62 feet) to6.0 m (19.69 feet) (Wide)1.0 m (3.28 feet) to3.4 m (11.16 feet) (Tele)ISO1600 1.15 m (3.77 feet) to8.6 m (28.22 feet) (Wide)1.0 m (3.28 feet) to4.8 m (15.75 feet) (Tele)The available focus range differsdepending on the recording mode.When you use the fl ash when youhave set ISO sensitivity to [AUTO], ISOsensitivity automatically becomes amaximum of [ISO1000].The edges of the picture may appeardark if you shoot a very close subject withthe fl ash while the zoom lever is close tothe W side. Zoom in slightly if this occurs.Available flash range varies dependingon ISO sensitivity in [HIGH SENS.].W: approximately 1.15 m (3.77 feet) to17.2 m (56.43 feet)T: approximately 1.0 m (3.28 feet) to9.6 m (31.49 feet)•■••••––