78RQT8346Changing the unit’s settingsWhen connecting with an HDMI cable to an amplifier, use thefollowing settings on this unit if you cannot set the speaker delayeffect on the amplifier.[1] Press [3, 4, 2, 1] to select the speaker icon (A) and thenpress [ENTER].[2] Press [3, 4] to select the setting and then press [ENTER].Icon examples:Surround speaker (LS)≥Large: Select when the speaker supports low-frequency (under100 Hz) reproduction.≥Small: Select when the speaker does not support low-frequencyreproduction.If the subwoofer is set to “No”, the front speakers will automaticallybe set to “Large”. (In this case, we recommend connecting aspeaker that can reproduce bass below 100 Hz.)(Effective when playing multi-channel audio)If either distance C or E is less than D, find the difference in therelevant table and change to the recommended setting.[1] Press [3, 4, 2, 1] to select the speaker icon (B) and thenpress [ENTER].[2] Press [3, 4] to select the setting and then press [ENTER].∫ Changing the speaker setting to suit yourspeakerSpeaker presence and size (A)Delay time (B)C Center speakerDifference SettingApprox. 34 cm (1 1 /10 feet) 1.0 msApprox. 68 cm (2 1 /5 feet) 2.0 msApprox. 102 cm (3 3 /10 feet) 3.0 msApprox. 136 cm (4 2 /5 feet) 4.0 msApprox. 170 cm (5 1 /2 feet) 5.0 msE Surround speakersDifference SettingApprox. 170 cm (5 1 /2 feet) 5.0 msApprox. 340 cm (11 feet) 10.0 msApprox. 510 cm (16 1 /2 feet) 15.0 msmsmsLCompleteLSRSWCRS0.00.0A B AAAABACenterFront (L) Front (R)Subwoofer(RS)(LS)CompleteSurroundLS LSLarge Small NoLS RSL RSWEDCC
