252DP-8032/80252008Ver.1.2Caution:Exercise caution not to scratch the surface of theOPC Drum (Green), and not to touch it with barehands.(41) Fasten the Process Unit with 1 Screw.(42) Connect the Harness, and reinstall the ConnectorCover and 1 Screw.Caution:When reconnect the Harness, make sure theconnector position and its keys. Insert it gently, and donot force the connector if it is facing the wrong way.Caution:When reinstalling the Connector Cover, make surethe Harness is not pinched by the Cover.(43) Shake the Toner Bottle 10 to 15 times to loosen thecontents.(44) Remove the Tape, however, do not open the Shutteror Toner will spill.(45) Insert the Toner Bottle into the Hopper Unit. Align theToner Bottle Key with the Key Alignment Channel ofthe hopper unit. Insert the Bottle as far as it will go,and turn the Toner Bottle clockwise until it locks inplace. (Bottle's Green Knob is lined up with the“Locked” symbol on the Process Unit label)(46) Install the Toner Waste Container.(47) Close the Front Cover and the Right Cover.(48) Load paper into all of the trays.(49) Plug the AC Power Cord.(50) If required, connect the LAN / USB Cable(not included).(51) Turn the Main Power Switch on the Back, and thePower Switch on the Left Side of the machine to theON position.Note:Perform the following adjustments after the machinehas warmed up, and displays:Ready To CopySet Originals
