309DP-8032/80252008Ver. 1.2〈Adjust the Scanning Position〉(32) Perform Service Mode F6 (No.71, 72, 73, 90, 91, 92, 93 and 94) to adjust the ADF Scanning Position.No. 90 / 711-Side / 2-SideADF Detection TimingNo. 92 / 731-Side / 2-SideADF Original Trailing EdgeRegistrationNo. 93 / 941-Side / 2-SideMagnification Ratio(Top Feed)No. 91 / 721-Side / 2-SideADF Original LeadingEdge RegistrationAdjust the ADF Unit to scan the lined part(inside of the margin 1.5 - 2.5mm)on the document as shown on the right.< When Adjusting the ADF Unit >(ADF Image ReadStart Position Adjustment)(Original Trail Edge DetectionTiming Adjustment)(Ratio Adjustment when thescan is made)ImageDataImageDataImageData(Original Lead Edge DetectionTiming Adjustment)0.05mm1 PointAADocument PrintedImage Adjustment AdjustmentAmount RemarksAPaperTravelRebooting isnot necessaryto enable theParameterSetting.i-ADF only.PaperTravelVoidShadow ofDocumentLeadingEdgePaperTravelReducedEnlargedVoidShadow ofDocumentLeadingEdge0.05mm1 Point0.3mm1 Point0.3mm1 Point0.3mm1 Point0.3mm1 Point0.1%1 Point0.1%1 Point71, 72, 73, 94are valid for
