Panasonic DVCPRO50 AJ-D960EG Operating Instructions Manual

Contents

ENGLISH103 (E)Error messagesWarning messagesPriority Monitor display Description VTR operationHigh UNKNOWN SIG No recording operationscan be performed.NOT 1×25M SIG No recording operationscan be performed.NOT 1×50M SIG No recording operationscan be performed.INVALID VIDEO SIG Operation continues*2No editing operationscan be performed.INVALID AUDIO SIG Operation continues*3No editing operationscan be performed.INVALID TC SIG Operation continues*4No editing operationscan be performed.FAN STOP Operation continuesNO RFOperation continuesSERVO NOT LOCKED Operation continuesLOW RFOperation continuesHIGH ERROR RATEOperation continuesOVER RECORDINGOperation continuesLow*1: The data stream format complies with the SMPTE 321M standard.*2: This warning appears only during recording operations. In cases like this, no signals are recorded on the tape and only theerasure of the existing signals will be performed.*3: This warning appears only during recording operations. In cases like this, the signals are recorded with the audio signalsmuted.*4: This warning appears only during recording operations. In cases like this, the internally generated time codes are recorded.This appears when the SDTI input signals are notDVCPRO or DV format signals*1.This appears when the SDTI input signals are notDVCPRO (25 Mbps) format 1× transfer signals.This appears when the SDTI input signals are notDVCPRO50 (50 Mbps) format 1× transfer signals.This appears when the compressed video signals in theSDTI input signals are invalid.This appears when the audio signals in the SDTI inputsignals are invalid.This appears when the time codes in the SDTI inputsignals are invalid.This is displayed when the fan motor stops.This appears during playback when a blank section (tapeblank) lasting for one or more seconds has been detected.Such a section is identified as a tape blank when all of thefollowing conditions are met.• No head outputs• No playback data readout• No CTL (Excluding DV and DVCAM tapes)This is displayed when the servo is not locked for three ormore seconds during playback, recording, or editing.This is displayed when envelope levels approximately 1/3that of normal levels are detected for more than onesecond during playback, recording, or editing.This is displayed when the error rate increases andcorrection/interpolation is performed on either the video oraudio playback signal.When voice-over editing is performed using the internalaudio memory, this message appears if the duration of thesignals recorded in the memory exceeds 20 seconds.