Panasonic DVCPRO50 AJ-D960EG Operating Instructions Manual

Contents

104 (E)Table of AUTO OFF Error messagesMonitor display Description VTR operation(Restart condition)CAP ROTATE TOOSLOWCAP TENSION ERRORDEWDRUM ROTATE TOOFASTE-FFDRUM ROTATE TOOSLOWIf the capstan motor speed is abnormally low, theAUTO OFF lamp lights, and the message displayflashes.STOP(POWER OFF→ON)If an abnormal tension at the supply side is detectedin the capstan mode, the AUTO OFF lamp lights, andthe message display flashes.STOP(POWER OFF→ON)If condensation is detected, the AUTO OFF lamplights, the message display flashes, and the VTR istransferred to the eject mode. After the tape isejected, the drum rotates in order to eliminate thecondensation.When the condensation has been eliminated, theAUTO OFF lamp and message display go off, and theVTR can be used.1)2)EJECT(Normal operationresumed aftercondensation iseliminated)If the cylinder motor speed is abnormally high, theAUTO OFF lamp lights, and the message displayflashes.STOP(POWER OFF→ON)If the tape start and tape end are detected simulta-neously either during or after loading, the AUTO OFFlamp lights, and the message display flashes.STOP(POWER OFF→ON)If condensation is detected in the eject mode, thedrum starts rotating as soon as it is detected.If condensation is detected when the cassette hasbeen inserted, the drum rotation is stopped, andafter the tape is ejected, the drum starts rotating.If the cylinder motor speed is abnormally low, theAUTO OFF lamp lights, and the message displayflashes.STOP(POWER OFF→ON)FRONT LOAD MOTOR If the cassette does not move up even when 6seconds have elapsed since the VTR was transferredto the eject mode, the AUTO OFF lamp lights, and themessage display flashes.If the cassette does not move down inside themachine even when 6 seconds have elapsed sincethe cassette was inserted, the VTR is transferred tothe eject mode.STOP(POWER OFF→ON)LOADING MOTOR When the unloading operation is not completed within6 seconds, the AUTO OFF lamp lights, and themessage display flashes.When the loading operation is not completed within 6seconds, the VTR is transferred to the eject (unload-ing) mode.STOP(POWER OFF→ON)FRONT LOAD ERROR The AUTO OFF lamp lights and the message displayflashes when the take-up reel has been rotating idlyfor a fixed period of time while the start/endprocessing operation during loading (half position) isbeing performed.STOP(POWER OFF→ON)Counter displayCAP ROTA TOOSLOWCAP TENSION ERRORDEWDRUM ROTA TOOFASTE-FFDRUM ROTA TOOSLOWFRONT LOAD MOTORLOADING MOTORFRONT LOAD ERRORDRUM TORQUEERRORWhen it has been detected that the cylinder motor issubject to an abnormal torque, the AUTO OFF lamplights, and the message display flashes.STOP(POWER OFF→ON)DRUM TORQUEERROR