Setup menus64 (E)USER menuItem SettingNo. Superimposed No. Superimposed Descriptiondisplay display100 SEARCH 0000 DIALENA 0001 KEY101 SHTL MAX 0000 ×8.40001 ×160002 ×32102 FF. REW 0000 ×16MAX 0001 ×320002 ×50103 AUDIO 0000 OFFMUTE 0001 ON104 REF 0000 OFFALARM 0001 ON105 AUTO EE 0000 S/F/RSEL 0001 STOP0002 BLACK0003 BLACK10004 GRAY0005 GRAY1The underline on the setting item denotes the initial setting.This selects the direct search dial operation.0: For direct search dial operations.1: Operation is not transferred to the search mode unless thesearch button is pressed.This sets the maximum speed for shuttle operations.0: 8.4 (7.0)× normal speed1: 16× normal speed2: 32× normal speedThe value for the DV/DVCAM format is shown in parenthesis( ).This sets the maximum speed for FF and REW operations.0: 16 (32)× normal speed1: 32 (60)× normal speed2: 50 (100)× normal speed• The speeds given in the parentheses apply in the DVCPRO(25 Mbps) mode.• With the DV/DVCAM format, the maximum speed is set to32× regardless of this item’s settings.This sets the status until the audio signal is output whenoperation switches from the stop or search modes to the playmode.0: The time until the audio is output is shortened.1: The audio is output after the status stabilizes.When set to 0 (OFF), the sound in the initially output part isincomplete. Therefore, this setting is not recommended forbroadcasts.This selects whether to warn the operator when theREF.VIDEO signal has not been connected.0: Warning is not given.1: Warning is given by the flashing STOP lamp.This selects the VTR mode in which the EE status isestablished when the TAPE/EE switch is set to EE.0: EE status is established in the STOP, FF or REW mode.However, EE status is always established in EJECT moderegardless of the TAPE/EE switch setting.1: EE status is established only in the STOP mode. However,EE status is always established in EJECT mode regardlessof the TAPE/EE switch setting.2: EE status is established only in the STOP mode. However,EJECT is set as follows depending on the setting of theTAPE/EE switch.At the EE setting; The EE status is established.At the TAPE setting; The picture turns black. The sound ismuted.3: EE status is established in the STOP, FF or REW mode.However, EJECT is set as follows depending on the settingof the TAPE/EE switch.At the EE setting; The EE status is established.At the TAPE setting; The picture turns black. The sound ismuted.4: EE status is established only in the STOP mode. However,EJECT is set as follows depending on the setting of theTAPE/EE switch.At the EE setting; The EE status is established.At the TAPE setting; The picture turns gray. The sound ismuted.5: EE status is established in the STOP, FF or REW mode.However, EJECT is set as follows depending on the settingof the TAPE/EE switch.At the EE setting; The EE status is established.At the TAPE setting; The picture turns gray. The sound ismuted.
