Panasonic DVCPRO50 AJ-D960EG Operating Instructions Manual

Contents

44 (E)Voice-over facility (internal)Operating procedure 21 Select INT_VO as the setup menu No. 317 (AUD MEM MODE) setting.2 Select the same setting for the channel (any channel from CH1 to CH4) on which thesound is to be recorded and for the setup menu No. 318 (AUD MEM CH) channel.3 Insert the cassette tape for which the voice-over editing is to be performed.4 Press the insert button for the channel (channel selected in step 2) on which the soundis to be recorded and ensure that its lamp lights.5 Enter the IN and OUT points of the positions where voice-over editing is to beperformed.6 Press the PREVIEW button.7 While watching the TV monitor, input the audio signals to be recorded between the INpoint and OUT point into the channel which was selected in step 2. The audio signals tobe recorded are stored in the memory.8 Press the AUTO EDIT button to proceed with editing. The audio signals stored in thememory are recorded from the memory onto the cassette tape.The audio signals can be previewed prior to editing by pressing the PREVIEW buttonwhile the SET button is held down before the AUTO EDIT button is pressed.T R 00:00:00:00m STOP“m” indicates the edit mode in whichthe internal memory is used.Memory capacity• Up to 20 seconds of sound can be stored in the unit’s internal memory. It should be borne inmind that even if an attempt is made to store more than 20 seconds of sound in thememory, all the audio signals in excess of the memory’s 20-second capacity will fail to bestored.• When INT_VO or INT_X, which is performed using the internal memory in the setup menuNo. 317 (AUD MEM MODE) setting, “m” appears on the front panel and is superimposedonto the TV monitor display to indicate that the editing mode using the internal memory isnow being used.