Automatic editing36 (E)POWERONOFFLLEVEL CH4 CUEDVCPROAUDIO ANALOGVIDEO Y PB PRAES/EBU USER SETCMPSTINPUT SELECTSDICH CONDITIONSCH CFSHIFT ADJ START RESETSTAND BYUB EXT EETC INTTC MODETAPELOCAL REV FWDPULLOPENJOGPUSHEJECTAUTO OFFSHTLSLOWCONTROLREMOTEEDITREWPLAYSERVOSTOPPLAYERRECREC INHIBITFFRECORDERTC/CTLTC SETINSERTCH2TRIMSET OUTINCH3 CH4 CUE TCAUTO EDIT PREROLLPREVIEWREVIEWRECPBPULL FOR VARIABLEPULLOPENHEADPHONESCH1 CH2RMETERFULL/FINEMONITOR SELECTW– +SDISDTI(V&A)ASMBL VIDEO CH14 5 6 7321AOUTAINMULTI CUECH38SLOW MOTION2 1, 3Checking the edit points1 Press the IN (or OUT) button to check the edit point.The value of the entered edit point appears on the display.2 Press the PREROLL button while holding down the IN (or OUT) button to check theimage at the edit point.The tape is cued at the edit IN (or OUT) point, and the still picture mode at that point isdisplayed.• The EE mode is established if the TAPE/EE switch has been set to the “EE” positionwhen “STOP” has been selected for the setup menu No. 315 (AFTER CUE-UP).3 Continue to hold the IN and OUT buttons down together, and check the edit section(duration time).The duration time appears on the display.Calculating the duration• When both edit points have been set, the duration between the two edit points.• When only one edit point has been set, the duration between the set data and the currenttape address.• When neither edit point has been set, the duration of the previously edited interval.