Parts and Their Functions GTWIN Reference Manual206Field DescriptionUnit (only visible whenyou activate "SD Card(Logging Data)"Note: see explanationfollowing table. 1 Year (Month unit): Displays the data for 12 months by month in 12 plots. Thegraph starts with January. 1 Month (Day unit): Displays the data for 31 days by day in 31 plots. 1 Day (Hour unit): Displays the data for 24 hours by hour in 24 plots. Number of Plots: Specify the desired number of plots on the right side under"Number of Plots".You can, for example, display the data for 1 hour beginning with the first value ofthe hour and continuing until the number of plots has been reached.No mathematical calculation can be performed on the data, i.e. no mean, total oraccumulated value.Direction Specify in which direction the reference devices sampled are displayed.Update Device Specify the device used to trigger updating the line. Subsequent devices triggersubsequent lines (see "Update Device" at the end of this section).Use Drawing CompleteBitSets a bit when the graph has been updated (see "Update Device" at the end of thissection).Number of Plots In block mode, the number of plots = number of reference devices sampled anddisplayed simultaneously on the line. If the number of plots is greater than the numberof devices sampled, the extra plots will be displayed as 0. The max. value will bedisplayed for all reference device values that exceed the max. value specified in theelement setup tab.Tip: Under "Element Setup [Setup] Color and Form", specify a "mark" to clearlyidentify each reference device sampled.DT100DT101DT102DT103DT104xxx xxData parts in combination with a keyboard part are used to enter 2 digits for the referencedevice for the year, month, day and hour. In the following table for the line graph part underElement Setup, GDT100 is specified as the unit device.Reference data forSD card, UnitData part referencedevice, exampleDescription1 Year (Month unit) GDT100:09 Data is sorted and read by the month.1 Month (Day unit) GDT100:09GDT101:10Data is sorted and read by the day.You need 1 data part for GDT100 (the year 2009)and 1 data part for GT101 (the month October).
