Panasonic HC-WXF1 Operating Instructions Manual

Also see for HC-V800: Basic operating instructions Basic owner's manual Basic operating instructions

- 215 -9 (When selecting [WEP]/[TKIP]/[AES])Touch [INPUT], then enter the Password.≥ For details on how to enter characters, refer to page 137.≥ When the entry is complete, touch [Enter].≥ A message is displayed when the connection is complete. Touch [EXIT], and exit [Set WirelessAccess Point].≥ Check the wireless access points instruction manual and settings when a saving wireless accesspoint.≥ The Encryption methods are [AES], [TKIP] and [WEP] in descending order of strength.We recommend you connect with the strongest possible Encryption method.≥ When the signal of the wireless access point is weak, a connection may not be established.Refer to “Messages” (l 265) and “Troubleshooting” (l 267) for details.≥ Transmission speed may decrease, or may not be usable depending on the environment it isused in.Setting up a direct connection to a smartphoneCheck the [Direct Connection Password] setting in [Wi-Fi Setup]. (l 221)≥ The default setting is [OFF].Select [ON] as needed, for example when the setting seems necessary for your Wi-Fienvironment.≥ When [Direct Connection Password] is set to [OFF]j Proceed to the following section, “When [Direct Connection Password] is set to [OFF]” in“Using [Remote Ctrl] with a direct connection”. (l 184)≥ When [Direct Connection Password] is set to [ON]If your smartphone is compatible with WPS, refer to “[Easy Connection (WPS)]”. If not, refer to“Connecting with QR code”.j Proceed to the following [Easy Connection (WPS)] (l 216)j Proceed to the “Connecting with QR code” (l 216)j Proceed to the “Connecting by entering an SSID and Password” (l 217)When the Wi-Fi connection is complete, refer to “When [Direct Connection Password] is set to [ON]”in “Using [Remote Ctrl] with a direct connection”. (l 185)Confirming that the Wi-Fi connection is completej The status indicator of this unit is lit greenj is displayed on the screen