- 143 -You can set the auto switch recording, simultaneous recording and background recording.≥ Insert SD cards to card slot 1 and card slot 2.*1 This effect cannot be set for Interval Recording.*2 This function is not available in the following cases:j When [REC FORMAT] is set to a setting with a size of C4K (4096k2160) or 4K (3840k2160)j When the bit rate of [REC FORMAT] is above 50 Mbps∫ Auto switch recordingThis is simple Relay Recording. It is possible to continuously record on the SD card in the other cardslot even when the available capacity of the SD card runs out during the recording. Note that therewill be a momentary pause in the sound when recording media is switched.≥ is displayed beside the display of the SD card selected as the recording destination of motionpictures in [MEDIA SELECT] (l 30). When the recording media is switched and auto switchrecording starts, will disappear from the location and instead be displayed beside the other SDcard display.≥ Even after switching of the recording media, you can replace the SD card that ran out of spacewith a new one and record the motion picture onto three or more SD cards. Since it may take awhile for this unit to recognise a new SD card, replace the SD card that ran out of space when theSD card currently being used as a destination still has sufficient remaining recordable time.∫ Simultaneous recordingSame motion picture can be recorded on two SD cards.≥ is displayed beside the display of the SD card selected as the recording destination ofmotion pictures in [MEDIA SELECT] (l 30).≥ If you set the recording destination of motion pictures to [SD CARD 1] in [MEDIA SELECT], theywill also be recorded to [SD CARD 2] simultaneously.≥ We recommend that you perform simultaneous recording using SD cards of the same SpeedClass rating and capacity.≥ Simultaneous recording is not possible when different types of SD cards (SDHC Memory Card/SDXC Memory Card) are used.∫ Background recordingYou can continue recording a motion picture by recording it on the SD card that is not set as arecording destination in [MEDIA SELECT] (l 30).≥ When the recording destination of motion pictures is set to [SD CARD 1] in [MEDIA SELECT](l 30), [SD CARD 2] will be used for background recording. The following instructions assumethat the recording destination of motion pictures is set to [SD CARD 1].≥ is displayed beside the SD card display for card 2.[2 SLOTS FUNC.][OFF]: Cancel the setting.[AUTO SW] *1: Set the auto switch recording[SIMULTANEOUS]: Set the auto simultaneous recording[BACKGROUND] *1, 2 : Set the background recording
