- 40 -∫ To emphasise the outline of imagesSetting [EVF/LCD DETAIL] to [ON] helps you achieve focus easier by emphasizing the outlines ofan image displayed on the LCD monitor and viewfinder.You can also adjust the emphasis level or change the frequency.≥ You can also enable or disable this function with the applicable USER button. (l 61)≥ These settings will not affect the images actually recorded.Adjusting the level of [EVF/LCD DETAIL]1 Select the menu.2 Touch / to adjust settings.3 Touch [ENTER].≥ Touch [EXIT] to exit the menu screen.Setting the peaking frequency of [EVF/LCD DETAIL]≥ [EVF/LCD DETAIL] is cancelled in following cases:j If you use Focus Assist (l 40)Push AFWhen using Manual Focus, you can temporarily use Auto Focus by pressing the PUSH AF button.1 Set this unit to Manual Focus. (l 39)2 Press and hold the PUSH AF button.≥ The focus position will be automatically adjusted for the subject at the centre of the screen.≥ If you set [AREA MODE] to [FOCUS], [FOCUS/IRIS] or [FOCUS/Y GET] and use Area Mode, thefocus position will be automatically adjusted to the subject you have touched. (l 68)≥ It will be cancelled when the button is released.≥ The focus position set by the Push AF will be maintained when cancelled.≥ Push AF does not work in following cases:j In Intelligent Auto Modej When the FOCUS A/M/¶ switch is set to [A]j When a remote control (commercially-available) is connected (l 6)Focus AssistYou can use Focus Assist by registering [FOCUS ASSIST] to a USER button.≥ This function is registered to the USER5 button by default.≥ Please refer to page 61 for details about setting the USER button.: [DISP SETUP] # [EVF/LCD DETAIL] # [ON]: [DISP SETUP] # [EVF/LCD PEAK LEVEL]: [DISP SETUP] # [EVF/LCD PEAK FREQ.] # [HIGH] or [LOW]MENUMENUMENU
