Priority Setting Method11-1 Provisioning with the standard configuration file1-2 Provisioning with the product configuration file1-3 Provisioning with the master configuration fileSettings configured from the Web user interface or the phone user interfaceAccording to the table, settings configured later override previous settings (i.e., settings listed lower in the tablehave a higher priority).Notice• Make sure to perform Reset to Factory Default before connecting the unit to a different phone system.Contact your phone system dealer/service provider for further information.2.4 Configuration File SpecificationsThe specifications of the configuration files are as follows:File FormatThe configuration file is in plain text format.Lines in Configuration FilesA configuration file consists of a sequence of lines, with the following conditions:• Each line must end with "".Note or alone may be acceptable under certain conditions.• Lines that begin with "#" are considered comments.• Configuration files must start with a comment line containing the following designated character sequence(44 bytes):# Panasonic SIP Phone Standard Format File #The hexadecimal notation of this sequence is:23 20 50 61 6E 61 73 6F 6E 69 63 20 53 49 50 2050 68 6F 6E 65 20 53 74 61 6E 64 61 72 64 20 466F 72 6D 61 74 20 46 69 6C 65 20 23• To prevent the designated character sequence being altered by chance, it is recommended that theconfiguration file starts with the comment line shown below:# Panasonic SIP Phone Standard Format File # DO NOT CHANGE THIS LINE!• Configuration files must end with an empty line.• Each parameter line is written in the form of XXX="yyy" (XXX: parameter name, yyy: parameter value).The value must be enclosed by double quotation marks.• A parameter line written over multiple lines is not allowed. It will cause an error on the configuration file,resulting in invalid provisioning.Configuration Parameters• The unit supports multiple telephone lines. For some parameters, the value for each line must be specifiedindependently. A parameter name with the suffix "_1" is the parameter for line 1; "_2" for line 2; ...; "_6"for line 6, and so on.Examples of setting the line (phone number) for accessing a voice mail server:Document Version 2015-07 Administrator Guide 512.4 Configuration File Specifications
