General FeaturesFeatures Guide 111.2 System AdministrationSystem Programming and Diagnosis with PersonalComputerDescriptionThe KX-TD500 system can be programmed and administered using a Personal Computer(PC). The Programming Guide is required to perform PC Programming. There are twoprogramming methods:On-Site ProgrammingBy connecting a PC to your system, System Programming and maintenance can be performedlocally.There are two ways available to perform the above:(Method 1.) Using the Serial Interface (RS-232C) portConnect the PC to the Serial Interface (RS-232C) port provided. The Basic Shelf isprovided with RS-232C Ports. RS-232C Port 1 (PROG) is used for System Programming,diagnostics and external system database storage (Save / Load) functions, and Port 2(SMDR) for Station Message Detail Recording (SMDR) only.(Method 2.) Using an internal modemInstall the optional Remote Card — RMT card (KX-T96196) or ERMT card (KX-TD50197). Connect an extension port to the modem. Assign the FDN of the modem bySystem Programming. Dial this number from the PC.Remote ProgrammingYou can perform System Programming and maintenance from a remote site using a PC. Installthe Remote Card and assign the Remote FDN by System Programming.Starting system administration from a remote location can be done using one of the followingways:a) [Call Transfer]• Call an extension (probably the Operator) from a remote location and request atransfer to the modem.b) [DISA]• Dial the "FDN of the modem" using the DISA feature.c) [DIL 1:1]• Assign the "FDN of the modem" as the destination of the DIL 1:1 feature.d) [DID / DID (ISDN)]• Program DID / DID (ISDN) feature so that the incoming telephone number isconverted to the "FDN of the modem."e) [TIE Lines]• Dial the "FDN of the modem."• Dial the TIE Line access code, the PBX Code and the "FDN of the modem."
