Handset Settings28Time settingsAlarmAn alarm will sound for 3 minutes at the settime once or daily. Set the date and timebeforehand (page 15).1 Press {j/OK}.2 Select “Handset Setup”, then press{>}.3 Select “Time Settings”, then press{>}.4 Select “Alarm”, then press {>} 2times.5 Select an alarm mode, then press {>}.– “Once”: The alarm will sound once atthe set time. Enter the desired day andmonth by selecting 2 digits for each.– “Daily”: An alarm will sound daily atthe set time.– “Off”: Turns the alarm off. Press {>}again, then press {ih} to finish.6 Enter the desired hour and minute byselecting 2 digits for each.L You can select “AM”, “PM” or 24-hourtime entry by pressing {*} repeatedly.7 Press {j/OK}.8 Select the ringtone that will sound at theset time, then press {>}.9 Select “Save”, then press {>}.10 Press {ih}.Note:L To stop the alarm, press any dial key.L When in talk or intercom mode, the alarmwill not sound until the call has ended.L The alarm will sound at the set time evenwhen the ringer volume is turned off.L If you select “Once”, the setting willchange to “Off” after the alarm sounds.Ringer setupRinger volume1 Press {j/OK}.2 Select “Handset Setup”, then press{>}.3 Select “Ringer Setup”, then press{>}.4 Select “Ringer Volume”, then press{>}.5 Press {e} or {v} repeatedly to selectthe desired volume.6 Press {>}.7 Press {ih}.Note:L Alarms will sound and the handset will ringfor intercom calls and when paged even ifthe ringer is turned off.Changing ringtonesYou can change the ringtone used by thehandset.“Ext. Ringtone”: Selects the ringtone foroutside calls.“Int. Ringtone”: Selects the ringtone forintercom calls.1 Press {j/OK}.2 Select “Handset Setup”, then press{>}.3 Select “Ringer Setup”, then press{>}.4 Select the desired item, then press {>}.5 Select the desired ringtone, then press{>}.6 Press {ih}.Note:L If you select one of the melody ringtones,the ringtone will continue to sound forseveral seconds if the caller hangs upTG1810_1822AL(e-e).book Page 28 Tuesday, March 1, 2005 6:46 PM