SMS (Short Message Service)42– Message Centre 2: 01983391Message Centre 1 is used for sending SMSmessages, and Message Centre 2 is usedfor receiving messages.L Consult your service provider for moreinformation.1 Press {j/OK}.2 Select “SMS”, then press {>}.3 Select “Public”, then press {>}.4 Select “Settings”, then press {>}.5 Enter “0000” (default base unit PIN).L If you changed the PIN, enter it (page36).6 Select “Message Centre1” or“Message Centre2”, then press {>}.7 Edit the number as necessary, thenpress {j/OK}.8 Select “Save”, then press {>}.9 Press {ih}.Note:L If your phone is connected to a PBX, youneed to add the PBX line access numberand a dialling pause to the beginning ofthe Message Centre 1 phone number.Sending a messageWriting and sending a newmessage1 Press {j/OK}.2 Select “SMS”, then press {>}.3 To access the public mailboxSelect “Public”, then press {>}.To access a private mailboxSelect the desired mailbox, press {>},then enter its password.4 Select “Create”, then press {>}.L If “^Use Last Text?” is displayed,you can use the text from the lastmessage you created by pressing{e}. This message will be displayedonly if the last message was createdusing the same mailbox you selectedin step 3.5 Enter the message (page 47), thenpress {j/OK}.6 Enter the destination phone number (20digits max.), then press {j/OK}.L To send the message to a party savedin the handset phonebook, press{k}, select the handset phonebookentry, then press {j/OK} 2 times.L To send the message to a party loggedin the caller list, press {e} or {v}repeatedly to select the party, thenpress {j/OK} 2 times.L To send the message to a phonenumber logged in the redial list, press{R} repeatedly to select the phonenumber, then press {j/OK} 2 times.L If you wish to send the message to theother party’s mailbox, enter the otherparty’s mailbox number after thedestination phone number.Example: The other party’s phonenumber is 123456 and their mailboxnumber is 1.Enter 1234561.If you do not enter the other party’smailbox number, the message will besent to the public mailbox.7 To save the message, select “Yes”,then press {>}.L To send the message without saving it,select “No”, then press {>}.8 To send the message, select “Send”,then press {>}.L To cancel sending, press {ih}.Note:L This unit supports SMS messages of up to612 characters, however, the maximumTG1810_1822AL(e-e).book Page 42 Tuesday, March 1, 2005 6:46 PM