Multi-unit Operation57To register a handset to an additionalbase unit (manual registration)You can register a handset to a base unitmanually using the following method.1 Press {j/OK}.2 Select “Handset Setup”, then press{>}.3 Select “Registration”, then press{>} 2 times.4 Select a base unit number, then press{>}.L This number is used by the handsetas a reference only.5 Press and hold {x} on the base unit forabout 3 seconds, until the registrationtone sounds.L If all registered handsets start ringing,press {x} to stop, then repeat thisstep.L After pressing {x}, the rest of thisprocedure must be completed within 1minute.6 Wait until “Enter Base PIN” isdisplayed, then enter “0000” (defaultbase unit PIN), then press {j/OK}.L If you changed the PIN, enter it (page36).L When the handset has beenregistered successfully, w will stopflashing. If keytones are turned on(page 32), a confirmation tone will beheard.Selecting a base unitWhen “Auto” is selected, the handset willautomatically use any available base unit itis registered to. When a specific base unit isselected, the handset will make and receivecalls using that base unit only. If the handsetis out of range of that base unit, no calls canbe made.1 Press {j/OK}.2 Select “Handset Setup”, then press{>}.3 Select “Select Base”, then press{>}.4 Select the desired base unit number, or“Auto”, then press {>}.L The handset starts searching for thebase unit.Cancelling a handsetA maximum of 6 handsets can be registeredto a base unit. A handset can cancel its ownregistration (or the registration of anotherhandset) that is stored in the base unit. Thiswill allow the base unit to “forget” thehandset.1 Press {j/OK}.2 Select “Base Unit Setup”, thenpress {>}.3 Enter “0000” (default base unit PIN).L If you changed the PIN, enter it (page36).4 Enter “335”.5 Select “Cancel Handset”, then press{>}.L The numbers of all handsetsregistered to the base unit aredisplayed.6 Select the handset(s) you want tocancel, by pressing the desired handsetnumber.L The selected handset number(s) willflash.L To cancel a selected handset number,press the number again. The numberwill stop flashing.7 Press {j/OK}.8 Select “Yes”, then press {>}.9 Press {ih}.TG1810_1822AL(e-e).book Page 57 Tuesday, March 1, 2005 6:46 PM