Useful Information46If you are satisfied with the operation of your telephone service after plugging in yourPermitted Attachment, your installation is completed.You will be unable to connect this Permitted Attachment if your telephone service consistsonly of a wall phone or an old style telephone which is not connected by means of amodern plug and socket. In such cases a new socket will need to be installed.Should the Permitted Attachment not operate when plugged into a socket, it is either faultyor unsuitable for operation with your telephone service. It should be returned to the storewhere purchased or an Authorised Service Centre.Service difficultiesIf at any time a fault occurs on your telephone service, carry out the following checksbefore you call for service:L Disconnect the Permitted Attachment and try using the service with the normaltelephone.L If the telephone service then operates satisfactorily, the fault is in your PermittedAttachment. Leave the Permitted Attachment disconnected and report the fault to itssupplier or agent to arrange for repair.L If when using the telephone the service is still faulty, report the fault to “ServiceDifficulties and Faults” for attention.You are required to keep this Permitted Attachment in good working order while it isconnected to your telephone service. Its construction or internal circuit must not bemodified in any way without permission.WARNING:This cordless telephone system does not incorporate provision for secrecy ofconversations. Appropriately tuned radio equipment and other cordless telephonesystems in close proximity may be used by a third party to monitor and possibly interruptconversations in progress when this system is on radio operation.TG2421AL_2422AL(e).book Page 46 Tuesday, March 15, 2005 6:29 PM