*1 If begins flashing on the base unit, replacethe batteries with new ones as soon aspossible. If you replace Ni-MH batteries withalkaline batteries, insert the Ni-MH batteriesinto the base unit again after the power isrestored so that they will be recharged.Battery saving mode settingThis feature allows the base unit to reduce itspower consumption by limiting the availablefunctions and therefore extend battery life during apower failure.The following settings are available:– “On”: The unit will work as a standardtelephone. Only the corded handset can beused to make and receive calls. (You cannotuse the base unit display, phonebook,one-touch dial, answering system,speakerphone, etc.)The base unit display is blank.– “Off” (default): You can use the full functionsof the base unit, but battery life is not extended.The brightness level for the base unit display islowered.Base unit1 MMENUN#1502 MbN: Select the desired setting.3 MSAVEN a MEXITNNote:R Once the battery saving mode is set to “On”,the unit rings with the volume level 1 even if theringer volume for the base unit is set to “Off” tolet you know an incoming call is being received.Panasonic Ni-MH battery performance(optional batteries) when operating on backupbattery powerOperation Saving modeOff OnIn continuous use 2 hoursmax.7 hoursmax.Not in use (standby) 3 hoursmax.8 hoursmax.Note:R Battery performance depends on the type ofbatteries.R Actual battery performance depends on usageand ambient environment.Note when setting upNote for connectionsR The AC adaptor must remain connected at alltimes. (It is normal for the adaptor to feel warmduring use.)R The AC adaptor should be connected to avertically oriented or floor-mounted AC outlet.Do not connect the AC adaptor to aceiling-mounted AC outlet, as the weight of theadaptor may cause it to become disconnected.Note for Ni-MH battery installationR Handset: Use the supplied rechargeablebatteries.R Handset/Base unit: For replacement, werecommend using the Panasonic rechargeablebatteries noted on page 4, 5.Note for battery chargingR It is normal for the handset to feel warm duringcharging.R Clean the charge contacts of the handset andcharger with a soft and dry cloth once a month.Before cleaning the unit, disconnect from poweroutlets and any telephone line cords. Cleanmore often if the unit is exposed to grease, dust,or high humidity.Intelligent eco modeThis feature automatically reduces handset powerconsumption by suppressing handset transmissionpower when the handset is close to the base unit.R When this feature is activated, is displayed.R Eco mode is turned off when the clarity boosteris activated (page 16).10 For assistance, visit www.panasonic.ca/english/supportGetting StartedTGF3xxC(en)_1216_ver011.pdf 10 2014/12/16 19:11:00