Panasonic KX-TGF350C Operating Instructions Manual

Industry Canada Notices and other informationNOTICE:This equipment meets the applicable Industry CanadaTerminal Equipment Technical Specifications. This isconfirmed by the registration number. The abbreviation,“IC:”, before the registration number signifies thatregistration was performed based on a Declaration ofConformity indicating that Industry Canada technicalspecifications were met. It does not imply that IndustryCanada approved the equipment.Users should ensure, for their own protection, that theelectrical ground connections of the power utility,telephone lines and internal metallic water pipe system,if present, are connected together. This precaution maybe particularly important in rural areas.NOTICE:The Ringer Equivalence Number (REN) assignedto each terminal device provides an indication of themaximum number of terminals allowed to be connectedto a telephone interface. The termination on aninterface may consist of any combination of devicessubject only to the requirement that the sum ofthe Ringer Equivalence Numbers of all the devicesdoes not exceed 5.The Ringer Equivalence Number (REN) ofthis unit: (found on the bottom of the unit).NOTICE:Operation is subject to the following twoconditions: (1) this device may not cause interference,and (2) this device must accept any interference,including interference that may cause undesiredoperation of the device.Privacy of communications may not be ensured whenusing this telephone.Some cordless telephones operate at frequencies thatmay cause interference to nearby TVs and VCRs.To minimize or prevent such interference, the base ofthe cordless telephone should not be placed near, or ontop of, a TV or VCR. If interference is experienced, movethe cordless telephone further away from the TV or VCR.This will often reduce, or eliminate, interference.RF Exposure Warning:This device complies with Industry Canadalicence-exempt RSS standard(s).L This product complies with IC radiation exposurelimits set forth for an uncontrolled environment.L To comply with IC RF exposure requirements,the base unit must be installed and operated20 cm (8 inches) or more between product andall person’s body.L This product may not be collocated or operatedin conjunction with any other antenna or transmitter.L The handset may be carried and operated with onlythe specific provided belt clip. Other non-tested beltclips or similar body-worn accessories may notcomply and must be avoided.For assistance, visit www.panasonic.ca/english/support 55Useful InformationTGF3xxC(en)_1216_ver011.pdf 55 2014/12/16 19:11:03