Panasonic KX-TGF350C Operating Instructions Manual

Key Operation2 or MEN Skip message (during playback)3 Enter the “Settings” menu4 Play new messages5 Play all messages6 Play greeting message76 Record greeting message8 Turn answering system onMPAUSEN Pause message*29 orMSTOPNStop recordingStop playback0 Turn answering system off*4*3 Erase currently playing message*5 Erase all messages*6 Reset to a pre-recorded greetingmessage*1 If pressed within the first 5 seconds of amessage, the previous message is played.*2 To resume playback:MbN: “Playback” a MSELECTN*3 You can also erase as follows:MPAUSEN a MbN: “Erase” a MSELECTNa MbN: “Yes” a MSELECTNCalling back (Call Display subscribers only)1 Press MPAUSEN during playback.2 MbN: “Call back” a MSELECTNEditing the number before calling back1 Press MPAUSEN during playback.2 MbN: “Edit & Call” a MSELECTN3 Press MEDITN repeatedly until the phonenumber is shown in the desired format(page 39). a M NErasing all messages1 MMENUN#3252 MbN: “Yes” a MSELECTN a MOFFNAdvanced new messagealerting featuresAudible message alertThis feature allows the base unit to beep to informyou of a new message arrival when newmessages are recorded. The base unit beeps 2times every minute until you listen to themessages, if the “Base unit beep” setting isturned on. The default setting is “Off”.You can configure this setting using either thebase unit or one of the handsets.Handset / Base unit1 MMENUN#3392 MbN: Select the desired setting. a MSAVEN3 Proceed with the operation for your unit.Handset: MOFFNBase unit: MEXITNNew message alert by a callThis feature allows you to receive a notification byphone when new messages are recorded. Thebase unit calls a phone number you specify. Youcan then operate the answering system remotelyto listen to the new message.To use this feature, you must:– store a phone number to which the unit makesthe call to.– turn on the new message alert setting.After you answer the new message alert call, youcan listen to messages from that call (page 44).You can configure this setting using either thebase unit or one of the handsets.Important:R A new message alert is stopped 1 minute afterthe unit starts to call. The unit will not retry thecall even if the call is not answered.Storing a phone number to which the unitmakes an alert callHandsetn From the phonebook:1 MMENUN#33842 For assistance, visit www.panasonic.ca/english/supportAnswering SystemTGF3xxC(en)_1216_ver011.pdf 42 2014/12/16 19:11:02