Panasonic KX-TGF372AZ Operating Instructions Manual

Also see for KX-TGF372AZ: Operating instructions

Contents

Panasonic KX-TGF372AZ Operating Instructions Manual Manual pdf 31 page image

Using the MCALL BLOCKNbuttonYou can press the MCALL BLOCKN button inthe following situations to disconnect thecurrent call and add a phone number to thecall block list:– when an incoming call is being received– when an incoming call is being recorded bythe answering system– when talking on an outside callOnce a phone number has been added to thecall block list, the unit will block calls from thatphone number in the future.Handset1 Press MCALL BLOCKN under thesituations shown above.2 Confirm the call block number and pressMYESN.R The call block number is stored in thecall block list, “Blocked caller” isdisplayed, and then the call isdisconnected.Note:R If the call has no phone number, the call isblocked but it is not stored in the call blocklist.R The call block feature is not available:– for intercom calls or calls received by callwaiting.– when a landline call (or mobile call) isbeing received during a mobile call (orlandline call).R Blocked calls are logged in the caller list.Storing unwanted callersThe unit can block calls by storing the desireditems in the call block list beforehand (CallerID subscribers only).– “Single number”: The unit blocks callsfrom specific phone numbers stored in thecall block list.– “Range of numbers”*1/“Range”*2: Theunit blocks calls that begin with a numberstored in the call block list, such as atoll-free phone number prefix or certainarea codes.– “Withheld”: The unit blocks calls thathave no phone number.*1 Handset*2 Base unitSingle phone numbers and ranges of numberscan be stored in the call block list up to 250items in total.Blocking unwanted callers:When a call is received, the unit rings briefly*1while caller information is being received.If the caller’s phone number matches an entryin the call block list, the unit emits no sound tothe caller, and disconnects the call.*1 If you do not want this one ring to sound,select “No” in “Setting not to ring once forblocked call” (page 32).Storing a single phone numberImportant:R We recommend storing 10 digits (includingthe area code). If only 7 digits are stored, allnumbers that have the same last 7 digitswill be blocked.Adding call blocked numbers fromthe caller listHandset1 MCN CID2 MbN: Select the desired entry to beblocked.3 MCALL BLOCKN4 MbN: “Yes” a MSELECTN5 Edit the phone number if necessary (24digits max.).6 MSAVEN a MOFFNBase unit1 MCIDN2 MbN: Select the entry to be blocked.3 MSAVEN4 MbN: “Nuisance call block” aMSELECTN31Nuisance Call BlockTGF372AZ(en)_0519_ver003.pdf 31 2015/05/19 9:28:44