Error messagesDisplay message Cause/solutionAccess # toVM serviceis not storedR You have not stored the voicemail access number.Store the number (page 68).Base no powerorNo link. Re-connect baseAC adaptor.orNo link.R Confirm the base unit’s AC adaptor is connected tothe unit and the power outlet correctly.R The handset has lost communication with the baseunit. Move closer to the base unit and try again.R Unplug the base unit’s AC adaptor to reset the unit.Reconnect the adaptor and try again.R The handset’s registration may have been cancelled.Re-register the handset (page 51).R When “No link.” is displayed during a powerfailure, place a handset on the base unit to supplypower to the base unit.Busy R No mobile phone is paired to the base unit. Pair amobile phone (page 16).R The called unit is in use.R Other units are in use and the system is busy. Tryagain later.R The handset you are using is too far from the baseunit. Move closer and try again.R Only 2 Bluetooth devices can be used with the unit atthe same time (for example, 2 mobile lines, or theheadset and 1 mobile line).Check tel line R The supplied telephone line cord has not beenconnected yet or not connected properly. Check theconnections (page 10).R If you do not connect the telephone line cord and useonly mobile lines, set the mobile line only mode(page 18).Error!! R Recording was too short. Try again.R Someone is using a mobile line or headset. Tryagain later.R The phonebook copy is incomplete (page 56). Themobile phone is disconnected from the base unit.Make sure that other Bluetooth devices are notconnected to the mobile phone, and try again.Failed R Although the unit tried to connect to the mobilephone or headset, the connection has been failed.– Someone is using a mobile line or headset. Tryagain later.– Make sure that the mobile phone or headset is notconnected to other Bluetooth devices.70Useful InformationTGF372AZ(en)_0519_ver003.pdf 70 2015/05/19 9:28:47