Release Sequence for Call WaitingSpecifies the sequence for releasing Call Waiting.DefaultFValue RangeMax. 16 digits consisting of 0–9, , # and special codesD: DisconnectingF: Flash (Recall)R: Ringback Tone DetectionT: Dial Tone Detection,: Dial Pause (default 1 s);: Dial Pause (default 3 s)X: Extension Dialing0–9, , #: Dial CodeReceiving Caller IDEnables or disables the VPS to receive Caller ID from the PBX while receiving a call.DefaultEnableValue RangeDisable, EnableWaiting Time for Receiving Caller IDSpecifies the length of time that the VPS waits before receiving Caller ID from the PBX. This parameter isneeded only when "Enable" is selected in "Receiving Caller ID".Default0 sValue Range0 s–10 sInband SignalingSet these parameters only if the Integration Mode is set to "Inband" under "PBX Environment". If the PBX typeis set to a KX-T series PBX, the Inband Signaling parameters will be automatically set to the default codes forthe KX-T series PBX.Note• Default values below vary depending on the setting of "PBX Type" in "PBX Environment".RingbackSpecifies the DTMF signal used to indicate a ringback tone. Sent to the VPS when the extension dialed isringing.Document Version 3.0 2010/06 Programming Manual 1572.5.4 Parameters
