Dial NumberAssigns a telephone or beeper number to Device 1, 2, or 3. The subscriber can also specify the number to bedialed by entering it from his or her telephone, allowing the subscriber to set this feature on a case by casebasis.Note• The callback number entry code "X" must be included in the number to be called if the "Beeper CallbackNo. Entry Mode" is set to any value other than "Disable" and "Type of Device" is set to "Beeper". Theproper number of dialing pauses must be inserted before the callback entry code.• When the VPS calls a trunk (CO line) via a PRI (ISDN Primary Rate Access Interface) card of aPanasonic PBX, please be sure to add "#" after the telephone number (1112223333 in the examplehere):Example: 9P1112223333#PP123PP456PPX# (P: Dial Pause)DefaultNoneValue RangeMax. 32 digits consisting of 0–9, , # and special codes:, : Dial Pause (default 1 s); : Dial Pause (default 3 s)T: Dial Tone DetectionX: Callback Number Entry Code0–9, , #: Dial CodesProgramming Manual References"Beeper Callback No. Entry Mode" in 2.1.4 Notification ParametersFeature Manual References2.2.32 Message Waiting Notification—DeviceType of DeviceSpecifies the type of device telephone or beeper that will receive message notification. The subscriber canalso specify the type of device from his or her telephone.DefaultTelephoneValue RangeTelephone, BeeperFeature Manual References2.2.32 Message Waiting Notification—DeviceNo. of RetriesSpecifies the number of times the VPS will try to send notification if the device is busy or if there is no answer.Document Version 3.0 2010/06 Programming Manual 572.1.4 Notification Parameters
