Panasonic MEMORY CARD CAMERA-RECORDER AG-AF100P Operating Instructions Manual

Also see for AVCCAM AG-AF100P: Operating instructions Operating instructions

Contents

Panasonic MEMORY CARD CAMERA-RECORDER AG-AF100P Operating Instructions Manual Manual pdf 17 page image

17 ShootingDuring shooting, you can record up to twochannels of sound. You can also switch the inputsound to be recorded on each of the channels tothe built-in microphones, external microphones oraudio equipment connected to camera.POWERFOCUS ..BARSEVF DTL CH1 SELINT(L)ONOFF ONOFFINPUT1AUDIOMIC POWER +48VINPUT1 INPUT2INPUT2INPUT1INPUT2CH2 SELWFMCOUNTER-RESET/TC SETZEBRA OISCH1 SELECT switchCH2 SELECT switchINPUT 1/2(MIC POWER +48V)switchesINPUT 1 switch INPUT 2 switchINPUT 1 terminal INPUT 2 terminalSwitching Audio InputUsing the built-in microphone1 Switch the CH1 SELECT switch to INT (L).Audio from the built-in microphone Lch is•recorded to audio channel 1.2 Switch the CH2 SELECT switch to INT (R).Audio from the built-in microphone Rch is•recorded to audio channel 2.Using an external microphone andaudio equipment1 Connect an external microphone or audioequipment to the INPUT 1/2 (XLR 3-pin)terminals. (Page 41)2 Use the INPUT 1/2 switches to switch theaudio input.LINE: (audio equipment is connected)Input level is 0 dBu.MIC: (an external microphone is connected)Input level is -50 dBu.You can change the input level to -60 dBuin the setup menus, RECORDING SETUPscreen MIC GAIN1 and MIC GAIN2. (Page 56)Be aware that sensitivity will be higher ifyou choose -60 dBu so you will record morenoise.3 When using the phantom microphone(which requires + 48V power supply),set the INPUT 1/2 (MIC POWER +48V)switches to ON.ON: (When using the phantom microphone)+48V power supply to INPUT 1/2 terminals.OFF: (When a phantom microphone is notconnected)No power supply for INPUT 1/2 terminals.The battery will discharge faster if you use a•phantom microphone.Set to OFF if you connect equipment not•compatible with +48V. You can damage suchequipment if you leave the setting at ON.When using the AG-MC200G (optional), set•the MIC GAIN item to -50 dBu.