Panasonic MEMORY CARD CAMERA-RECORDER AG-AF100P Operating Instructions Manual

Also see for AVCCAM AG-AF100P: Operating instructions Operating instructions

Contents

Panasonic MEMORY CARD CAMERA-RECORDER AG-AF100P Operating Instructions Manual Manual pdf 24 page image

24Clip metadata (continued)Using the CounterCounter displayYou can display a counter that indicates how muchtime has elapsed during shooting or playback.1 Press the COUNTER button.Each time you press the button, the displaychanges as follows. (Page 45)0 : 00. 00 (CAM mode only)Counter valueDisplayed when TOTAL is selected fromthe REC COUNTER item in the DISPLAYSETUP screen of MENU settings.CLIP 0 : 00 . 00Displayed when CLIP is selected in theREC COUNTER item on the settings menuDISPLAY SETUP screen.Values are automatically reset whenrecording is started, and counter values aredisplayed for each individual clip.TC 12 : 34 : 56 . 01Time code value (Display time code framedigits in 24 frames when 24P is set, and in30 frames when any other format is set.)UB 12 34 56 78User informationNo display:Data is not displayed.TC preset modeWhen shooting using a multi-camera, you cansynchronously set the initial values of time code.The camera used for synchronization is theMASTER and the camera being synchronized isthe SLAVE.1 Connect the TC PRESET IN/OUT terminals(VIDEO OUT terminals) on the two deviceswith a pin cable, and turn on the power.MASTER settings■2 Check that the MASTER camera is set to theCAM mode, and set the EXT TC LINK itemon the setting menu TC/UB SETUP screen toMASTER.OUTPUTTING LTC SIGNAL is displayed onthe screen, and the time code is output fromthe TC PRESET IN/OUT terminal (VIDEO OUTterminal).Select the same REC FORMAT setting for•both the MASTER and SLAVE cameras,and set the TCG item on the TC/UB SETUPscreen to FREE RUN.To cancel the time code output, press the•MENU button.SLAVE settings■3 Set the EXT TC LINK item on the settingmenu TC/UB SETUP screen to SLAVE.4 Press the COUNTER - RESET/TC SETbutton. TCG values will be reset to the TCvalues inputted from the MASTER.TC LINK OK will be displayed for•approximately 2 seconds when the menuscreen is closed.If the TC values cannot be set correctly, LINK•NG will be displayed.If the SLAVE device is set to 24P, please set•the TC MODE item on the MASTER deviceto NDF.To cancel the SLAVE mode, press the MENU•button.∗ The COUNT value is indicated as a four-digitnumber. The COUNT value is incremented eachtime a new clip is captured if clip metadata hasbeen read in and TYPE2 has been selected asthe recording method.The COUNT value can be reset using thefollowing procedure.Press the MENU button, select META DATA→CLIP COUNT RESET→YES, and push theOperation lever to reset the counter value to 1.