Panasonic NV-MX2 Operating Instructions Manual

Contents

Panasonic NV-MX2 Operating Instructions Manual Manual pdf 11 page image

11112112341OPEN/EJECT12PUSHCLOSE34R E CSAVELens Cap and Grip BeltTo protect the Lens surface, attach the Lens Cap. Adjust the length of theGrip Belt to the size of your hand.1 Pass the longer loop of the Lens Cap Cord through theattached eye on the Lens Cap.2 Then pass the shorter loop of the Lens Cap Cord throughthe centre of the longer loop and pull tight.3 Attach the Lens Cap to the Grip Belt.4 Put your hand through the Grip Belt and adjust the length.≥The removed Lens Cap can be hooked onto the Grip Belt 1. (When youare not recording, be sure to keep the Lens Cap attached to the Lens forprotection.)~~~~~~~~~~~~~~~~~~~~~~~~~Attaching the Shoulder StrapWe recommend that you attach the Shoulder Strap before going out of doorsto record so as to avoid dropping the Movie Camera.1 Pull the end of the Shoulder Strap through the ShoulderStrap Holder on the Movie Camera.2 Fold the tip of the Shoulder Strap, run it through theShoulder Strap Length Adjuster, and pull it.≥Pull it out more than 2 cm 1 from the Shoulder Strap Length Adjusterso that it cannot slip off.~~~~~~~~~~~~~~~~~~~~~~~~~Inserting a CassetteWhen power is supplied to the Movie Camera, the Cassette can be taken outwithout turning the Movie Camera [ON].1 Slide the [OPEN/EJECT] Lever to the right and pull down toopen the Cassette Compartment.2 Insert a Cassette.3 Close the Cassette compartment and lock the CassetteCompartment by pressing the [PUSH CLOSE] mark.4 Close the Lower Cassette Compartment Cover.ªAccidental Erasure PreventionOpening the accidental erasure prevention slider 1 on the cassette (bysliding it in the [SAVE] arrow direction) prevents recording. To enablerecording, close the accidental erasure prevention slider (by sliding it in the[REC] arrow direction).≥For other notes concerning this item, see page 47.