Panasonic NV-MX2 Operating Instructions Manual

Contents

Panasonic NV-MX2 Operating Instructions Manual Manual pdf 9 page image

9115˚15˚15˚15˚ZOOMINDEX INDEXSELECTSTORESTOPK LºOSDCOUNTERV/REWSTILL ADVOFF/ONP.B.DIGITALDATE/TIMERESET TITLETWsVOLr´RECMULTI/P-IN-PPHOTOSHOTSTART/STOPA.DUBPLAYPAUSEFF/WSTILL ADVMENUITEMSET6 1 5;E DVAR.SEARCH P.B.ZOOM2 11321ªInserting a Button-type BatteryBefore using the Remote Controller, insert the supplied button-type battery.1 While pressing the Stopper 1, pull out the Battery Holder.2 Insert the button-type battery with the imprint (i) facingupward.3 Insert the Battery Holder into the Remote Controller.≥When the button-type battery is exhausted, replace it with a new CR2025battery. (A battery is normally expected to last about 1 year. However, itdepends on operation frequency.)≥Make sure to match the poles correctly when inserting the battery..........................................................................................................................WARNING“THE LITHIUM BATTERY IS A CRITICAL COMPONENT (TYPE NUMBERCR2025 MANUFACTURED BY PANASONIC).IT MUST NEVER BE SUBJECTED TO EXCESSIVE HEAT ORDISCHARGE. IT MUST THEREFORE ONLY BE FITTED IN EQUIPMENTDESIGNED SPECIFICALLY FOR ITS USE.REPLACEMENT BATTERIES MUST BE OF THE SAME TYPE ANDMANUFACTURER.THEY MUST BE FITTED IN THE SAME MANNER AND LOCATION AS THEORIGINAL BATTERY, WITH THE CORRECT POLARITY CONNECTIONSOBSERVED.DO NOT ATTEMPT TO RE-CHARGE THE OLD BATTERY OR RE-USE ITFOR ANY OTHER PURPOSE. IT SHOULD BE DISPOSED OF IN WASTEPRODUCTS DESTINED FOR BURIAL RATHER THAN INCINERATION.”.........................................................................................................................~~~~~~~~~~~~~~~~~~~~~~~~~ªUsing the Remote Controller1 Direct the Remote Controller to the Remote Control Sensorof the Movie Camera and press an appropriate button.≥Distance from the Movie Camera: Within approximately 5 metres≥Angle: Within approximately 15o in the vertical and horizontal directionsfrom the central axis.≥The above operating ranges are for indoor use. Outdoors or under stronglight, the Movie Camera may not operate properly even within the aboveranges.≥Within a 1-metre range, you can also use the Remote Controller on the side(the [MENU] Button side) of the Movie Camera.Selecting Remote Controller ModesWhen 2 Movie Cameras are used simultaneously, they can be operatedindividually by selecting different Remote Controller Modes.≥If the Remote Controller Mode of the Movie Camera and that of the RemoteController do not match, [REMOTE] Indication is displayed.Setup on the Movie Camera:Set [REMOTE] on the [OTHER FUNCTIONS] Sub-Menu to the desiredRemote Controller Mode.(l13)Setup on the Remote Controller:[VCR1]:Press the [D] Button and [∫] Button simultaneously. 1[VCR2]:Press the [E] Button and [∫] Button simultaneously. 2≥When the battery in the Remote Controller is replaced, the mode isautomatically reset to [VCR1] Mode.