Chapter 4 Settings — [PROJECTOR SETUP] menuENGLISH - 1194) Press qw to switch the item.[9600]Select the proper speed.[19200][38400]5) Press as to select [(OUT) PARITY].6) Press qw to switch the item.f The items will switch each time you press the button.[NONE]Select the parity condition.[EVEN][ODD]Setting the response1) Press as to select [RS-232C].2) Press the button.f The [RS-232C] screen is displayed.3) Press as to select [RESPONSE(ID ALL)].4) Press qw to switch the item.[ON] Returns the response when the ID setting is ALL.[OFF] Does not return the response when the ID setting is ALL.5) Press as to select [GROUP].6) Press qw to switch the item.[A] - [Z] Controls multiple projectors simultaneously by sending the ID of RS-232C. You can set groups from[A] to [Z]. The projector responds when the ID of RS-232C matches the setting.7) Press as to select [RESPONSE(ID GROUP)].8) Press qw to switch the item.[ON] Returns the response when the ID setting is GROUP.[OFF] Does not return the response when the ID setting is GROUP.Notef When [INPUT SELECT] is set to [DIGITAL INTERFACE BOX], communication using that serial terminal is available only when thecorresponding device (such as the optional Digital Interface Box (Model No.: ET-YFB100G)) is connected to the terminal.f When transferring logos via the optional Digital Interface Box (Model No.: ET-YFB100G), “NO SIGNAL SLEEP” of ET-YFB100G must be setto “OFF” to avoid cutting off communication.f When [INPUT SELECT] is set to [DIGITAL INTERFACE BOX], communication speed is fixed to 9 600 bps.[STATUS]Display the status of the projector.1) Press as to select [STATUS].2) Press the button.f The [STATUS] screen is displayed.3) Press qw to switch the pages.f The page will change each time you press the button.[INPUT] Displays the input terminal currently selected.[SIGNAL NAME] Displays the input signal name.
