Panasonic PT-DZ870E Operating Instructions Manual

Also see for PT-DW830E: Operating instructions (functional manual)

Contents

Panasonic PT-DZ870E Operating Instructions Manual Manual pdf 141 page image

Chapter 4 Settings — [NETWORK] menuENGLISH - 141Error information pageWhen [Error (Detail)] or [Warning (Detail)] is displayed in the self-diagnosis display of the [Projector status] screen, click it to display theerror/warning details.f The projector may go into the standby status to protect the projector depending on the contents of the error.11 Self-diagnosis result displayDisplays the item check results.[OK]:Indicates that operation is normal.[FAILED]:Indicates that there is a problem.[WARNING]:Indicates that there is a warning.r [FAILED] itemsParameter Description[MAIN CPU BUS] There is a problem with the microcomputer circuitry. Consult your dealer.[FAN] There is a problem with the fan or the fan drive circuit. Consult your dealer.[INTAKE AIR TEMPERATURE] The air intake temperature is too high. The projector may be used in an environmentwhere the temperature is high, such as near a heating appliance.[OPTICS MODULE TEMPERATURE]The temperature around the optics module inside the projector is high. The projectormay be used in an environment where the temperature is high, such as near a heatingappliance.[AROUND LAMP TEMPERATURE] The temperature around the lamp is high. The air exhaust port may be blocked.[LAMP1 REMAIN TIME] The runtime of the lamp has exceeded the specified time, and it is time to replace thelamp.[LAMP2 REMAIN TIME][LAMP1 STATUS] The lamp has failed to turn on. Wait a while until the luminous lamp cools off, and thenturn on the power.[LAMP2 STATUS][APERTURE(CONTRAST-SHUTTER)] There is a problem in the contrast shutter circuit for dynamic iris. Consult your dealer.[SHUTTER(MUTE-SHUTTER)] There is a problem with the shutter circuitry. Consult your dealer.[INTAKE AIR TEMP.SENSOR] There is a problem with the sensor used to detect intake temperature. Consult yourdealer.[OPTICS MODULE TEMP.SENSOR] There is a problem with the sensor used to detect temperature inside the projector.Consult your dealer.[AROUND LAMP TEMP.SENSOR] There is a problem with the sensor used to detect exhaust air temperature. Consult yourdealer.[BATTERY] Battery replacement is required. Consult your dealer.[COLOR WHEEL] There is a problem with the color wheel or the color wheel drive circuit. Consult yourdealer.[LENS MOUNTER] There is a problem in the lens mounter. Consult your dealer.[COVER OPEN] Installation of the lamp unit cover is incomplete. Check the installation of the lamp unitcover. (x page 162)[BRIGHTNESS SENSOR] There is a problem with the luminance sensor. If problems persist even after switchingon the power, consult your dealer.[ANGLE SENSOR] There is a problem with the sensor that detects angle. Consult your dealer.[AIR FILTER CASE] The air filter case is not attached. Check the attachment of the air filter unit.(x page 160)