Chapter 4 Settings — [NETWORK] menu136 - ENGLISH4) Press as to select [STORE], and press the button.5) When the confirmation screen is displayed, press qw to select [OK], and press the button.Notef When using a DHCP server, confirm that the DHCP server is running.f Consult your network administrator regarding the IP address, subnet mask, and default gateway.[NETWORK CONTROL]Set up the control method of the network.1) Press as to select [NETWORK CONTROL].2) Press the button.f The [NETWORK CONTROL] screen is displayed.3) Press as to select an item, and press qw to change the setting.[WEB CONTROL] Set to [ON] to control with the web browser.[PJLink CONTROL] Set to [ON] to control with the PJLink protocol.[COMMAND CONTROL] Set to [ON] to control with the / terminal control command format(x page 175). Refer to “Control commands via LAN” (x page 170).[COMMAND PORT] Set the port number used for command control.[CRESTRON RoomView] Set to [ON] to control with RoomView of Crestron Electronics, Inc.[AMX D.D.]Set to [ON] to control with the controller of AMX Corporation.Setting this function to [ON] enables detection through “AMX Device Discovery”. For details, refer tothe website of AMX Corporation.URL http://www.amx.com/[EXTRON XTP]Set to [ON] when connecting the “XTP transmitter” of Extron Electronics to the terminal.The [EXTRON XTP] setting must be set to [OFF] when connecting the optional Digital Interface Box(Model No.: ET-YFB100G).For details of the “XTP transmitter”, refer to the website of Extron Electronics.URL http://www.extron.com/[STORE] Save the current network control settings.4) Press as to select [STORE], and press the button.5) When the confirmation screen is displayed, press qw to select [OK], and press the button.[NETWORK STATUS]Display the status of the projector network.1) Press as to select [NETWORK STATUS].2) Press the button.f The [NETWORK STATUS] screen is displayed.[DIGITAL INTERFACE BOX]When the optional Digital Interface Box (Model No.: ET-YFB100G) is connected to the terminal, the main menu ofET-YFB100G is displayed. Refer to the Operating Instructions of ET-YFB100G for details.Notef When [EXTRON XTP] is set to [ON], [DIGITAL INTERFACE BOX] cannot be selected.f The operation guidance for the “RETURN” button is displayed on the menu screen of the Digital Interface Box. The projector does not havethe “RETURN” button, but same operation is available with the [Art-Net SETUP]Settings to use the Art-Net function is executed.1) Press as to select [Art-Net SETUP].2) Press the button.f The [Art-Net SETUP] screen is displayed.
