Chapter 4 Settings — [PROJECTOR SETUP] menu116 - ENGLISH[STANDBY MODE]Set the power consumption during the standby.1) Press as to select [STANDBY MODE].2) Press qw to switch the item.f The items will switch each time you press the button.[NORMAL] Use this setting to use the network function during standby.[ECO] Use this setting to reduce power consumption during standby.Notef In the [ECO] setting, the network function, the terminal, and some RS-232C commands become inoperable during standby.In the [NORMAL] setting, the network function and the terminal become operable during standby.f When set to [ECO], it may take approx. 10 seconds longer before the projector starts projecting after the power is turned on, compared withwhen [NORMAL] is set.f The [STANDBY MODE] setting is not reset to the factory default even when [ALL USER DATA] is executed from the [PROJECTOR SETUP]menu → [INITIALIZE] (x page 123).[SCHEDULE]Set the command execution schedule for each day of the week.Enabling/disabling the schedule function1) Press as to select [SCHEDULE].2) Press qw to switch the item.f The items will switch each time you press the button.[OFF] Disables the schedule function.[ON] Enables the schedule function. Refer to “How to assign a program” (x page 116) or “How to set aprogram” (x page 116) for how to set the schedule.Notef When [SCHEDULE] is set to [ON], the [STANDBY MODE] setting is forcibly switched to [NORMAL], and the setting cannot be changed.Even if [SCHEDULE] is then set to [OFF] when in this state, the setting of [STANDBY MODE] remains at [NORMAL].How to assign a program1) Press as to select [SCHEDULE].2) Press qw to select [ON], and press the button.f The [SCHEDULE] screen is displayed.3) Select and assign program to each day of week.f Press as to select the day of week, and press qw to select a program number.f You can set the program from No.1 to No.7. “- - -” indicates that the program number has not been set.How to set a programSet up to 16 commands to each program.1) Press as to select [SCHEDULE].2) Press qw to select [ON], and press the button.f The [SCHEDULE] screen is displayed.3) Press as to select [PROGRAM EDIT].4) Press qw to select a program number, and press the button.5) Press as to select a command number, and press the button.f You can change the page using qw.6) Press asqw to select [TIME], and press the button.
