|
Chapter 1 Preparation — About your projectorENGLISH - 25About your projectorRemote control13245768910 15121113141617Front TopBottom1 Power standby <v> buttonSets the projector to the state where the projector is switchedoff (standby mode) when the switch on theprojector is set to and in projection mode.2 Power on <b> buttonStarts projection when the switch on theprojector is set to when the power is switched off(standby mode).3 Remote control indicatorFlashes if any button in the remote control is pressed.4 Lens (, , ) buttonsAdjusts the projection lens. (x page 58)5 asqw buttonsUsed to navigate through the menu screen. (x page 65)6 buttonSwitches on (display)/off (hide) the on-screen display function.(x page 61)7 Input selection (, , ,Switches the input signal to project. (x page 62)8 buttonAssigns a frequently used operation as a shortcut button.(x page 63)9 Number (<0> - <9>) buttonsUsed when the system uses multiple projectors.Used to input ID numbers or passwords.10 buttonAutomatically adjusts the image display position while projectingthe image.[PROGRESS] is displayed on the screen while adjustingautomatically. (x page 63)11 buttonUsed when temporarily turning off the image. (x page 61)12 buttonDisplays the test pattern. (x page 63)13 buttonDisplays the projector information.14 buttonResets the content of the sub-menu to the factory default.(x page 66)15 buttonSets the ID number of the remote control to use for a systemusing multiple projectors. (x page 29)16 Remote control signal transmitter17 Remote control wired terminalConnects to the projector with a cable. (x page 30)Attentionf Do not drop the remote control.f Avoid contact with liquids or moisture.f Do not attempt to modify or disassemble the remote control.Notef When operating the remote control by directly pointing the receiver of the projector, operate the remote control at a distance approx. 30 m(98'5") or shorter from the remote control receiving section. The remote control can control at angles of up to ±30° vertically and horizontally,but the effective control range may be reduced.f If there are any obstacles between the remote control and the remote control signal receiver, the remote control may not operate properly.f The signal will be reflected off the screen. However, the operating range may be limited from light reflection loss due to the screen material.f If the remote control signal receiver directly receives strong light, such as fluorescent light, the remote control may not operate properly. Useit in a place distant from the light source.f The power indicator will flash if the projector receives a remote control signal.
|
