Chapter 2 Getting Started — Setting up32 - ENGLISHSetting upInstallation modeThere are six ways to set up the projector. Set the [PROJECTOR SETUP] menu → [PROJECTION METHOD] (x page 108) depending onthe installation method. Set [COOLING CONDITION] to [AUTO]. Using the projector with [COOLING CONDITION] set incorrectly may shortenthe life of the lamp.Mounting on the ceiling and projecting forward Setting on a desk/floor and projecting from rear(Using the translucent screen)Menu item Method Menu item Method[PROJECTION METHOD] [FRONT/CEILING] [PROJECTION METHOD] [REAR/FLOOR][COOLING CONDITION] [AUTO] [COOLING CONDITION] [AUTO]Mounting on the ceiling and projecting from rear(Using the translucent screen)Setting on a desk/floor and projecting forwardMenu item Method Menu item Method[PROJECTION METHOD] [REAR/CEILING] [PROJECTION METHOD] [FRONT/FLOOR][COOLING CONDITION] [AUTO] [COOLING CONDITION] [AUTO]Portrait setting and projecting from the rear*1(Using the translucent screen)Portrait setting and projecting forward*1Menu item Method Menu item Method[PROJECTION METHOD] [REAR/FLOOR] [PROJECTION METHOD] [FRONT/FLOOR][COOLING CONDITION] [PORTRAIT SETTING]*2 [COOLING CONDITION] [PORTRAIT SETTING]*2*1 For the portrait setting, use the optional Replacement lamp unit (for portrait mode) (Model No.: ET-LAD120P (1 pc), ET-LAD120PW (2 pcs)).*2 Using the optional Replacement lamp unit (for portrait mode) (Model No.: ET-LAD120P (1 pc), ET-LAD120PW (2 pcs)) will set the cooling conditionto [PORTRAIT SETTING].Notef In the portrait setting, the on-screen menu is displayed sideways.Parts for ceiling mount (optional)You can install the projector on the ceiling using the optional Ceiling Mount Bracket (Model No.: ET-PKD120H (for high ceilings), ET-PKD120S(for low ceilings), and ET-PKD120B (Projector Mount Bracket)).f Be sure to use the Ceiling Mount Bracket specified for this projector.f Refer to the Installation Instructions supplied with the Ceiling Mount Bracket when installing the projector with the bracket.
